STRAP 1121567 - Caterpillar

Terminal Messages
Status Messages - Status messages indicate that the terminal is performing an operation that may limit access to the terminal. The message will disappear when the terminal completes the operation or when the condition is satisfied.Reminder Messages - Reminder messages indicate a minor fault or mistake. Reminder messages appear when an invalid operation is attempted. Pressing any button on the touchscreen will remove the message.Warning Messages - Warning messages indicate that the operation may produce undesirable results. A warning message must be responded to as indicated in the message.Fault Messages - Fault messages indicate that the terminal has detected a condition which will prevent further operation. The current application will halt. The terminal must be reset in order to recover from this type of error.See the following table for information about individual terminal messages:
Table 1
Error Number    Terminal Messages    Type    Meaning    Recommended Action    
200-206, 300, 318-321, 328, 329, 331, 346, 347, 355, 356, 358, 367, 404, 411, 416, 417, 421-425, 447-449, 457, 459, 700, 1105, 1111, 1113, 1115, 1207-1211, 2002-2009, 2016, 2018, 2021, 2028 and 2029     A fault has occurred. Error = X     Minor Fault or Terminal Fault     A minor fault was detected that could impact terminal operation or a terminal fault was detected.     Press any key to recover from a minor fault. For terminal faults, contact technical support with the error code.    
208     Write to logic controller failed     Comm Status     Controller does not accept data from the terminal. Controller is not connected.     Check connections (on Remote I/O units). Verify that controller is in run mode and not busy. Verify that controller data files are not in use by other applications.    
303     Aborted.     Reminder / File Transfer Status     The terminal received an abort command during a file transfer.     Try again.    
304     File read access error     Reminder     Error reading the source file from a source device.     Try again. If problem continues, contact technical support.    
305     File write access error     Reminder     Error writing source file.     Try again. If problem continues, contact technical support.    
307     File not supported     Reminder / File Transfer Status     File is incompatible with the terminal's firmware.     Contact technical support to verify compatibility. File must be a .PVA file.    
308     Timeout     Reminder / File Transfer Status     The terminal was waiting for the partner device in a file transfer, but the terminal timed out before the data or expected reply was received.     Check cable connections or data corruption with noise on cable. Verify that the computer was not reset. Try again.    
309-311     Data corrupted. Verify file and retry.     Reminder / File Transfer Status     The data checksum failed in a file transfer.     Check electrical and cable connections. Try the file transfer again.    
312     Unknown device     Reminder / File Transfer Status     Verify the