STRAP 1503960 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Do not allow any dirt or foreign material to get into the hydraulic system during assembly, connection of lines, when components are filled with fluid, or during any maintenance operation.
Personal injury or death can result from sudden work tool movement.Sudden movement of the work tool can cause injury to persons near the work tool.To prevent injury or death, make sure that the area around the work tool is clear of personnel and obstructions before operating the work tool.
Reference Section
G310B G315B G325B - Caterpillar Brand (S/N: L9X1-UP; L3S1-UP; G7B1-UP; CZG1-UP)
Operation and Maintenance Manual, SEBU8742
Parts Manual, SEBP5680
Service Manual, RENR4464VRG-20/2 VRG-25/2 VRG-30/2 VRG-40/2 - Verachtert Brand (S/N: LSS1-UP; LAF1-UP; G6Z1-UP; FEC1-UP)
Operation and Maintenance Manual, SEBU8743
Parts Manual, SEBP5681
Service Manual, RENR4466G315B WH - Caterpillar Brand (S/N: AC21-UP)
Operation and Maintenance Manual, SEBU9231
Parts Manual, SEBP6540
Service Manual, UENR5265Required Parts
Table 1
Required Parts List
Item Qty Part Number Description
1 1 509-2130 Plug
2 1 443-6258(1) Seal Kit
(1) Only use the O-ring and back-up ring in the seal-kit packaging as shown in Illustration 3
Illustration 3 g06126114
(1) Plug without seals and back-up rings
(2) Partial consist of Seal-Kit
Replacement Procedure
Illustration 4 g06126121
(C) Grapple
(D) Shell
Illustration 5 g06126122
View of B-B
(E) 347-6992 Load Holding Valve
Rotate shells (D) until both of the shells (D) are parallel to the ground.
Partly close shells (D) to get access to load holding valve (E).Note: The load holding valve can be accessed from the side of grapple (C) as shown in Illustration 5.
Lower grapple (C) until the grapple (C) is on the ground.
Stop the engine of the host machine. Cycle all of the controls in order to remove the pressure from the hydraulic system.
Close the valves on the auxiliary lines.
Place a suitable container under grapple (C).Note: Dispose of the oil in a proper manner.
Illustration 6 g06126125
(E) 347-6992 Load Holding Valve
(F) Hydraulic cylinder
Remove load holding valve (E). Discard the part.
Illustration 7 g06126114
(1) Plug without seals and back-up rings
(2) Partial consist of Seal-Kit
Install seals (2) onto plug (1).
Tighten plug to 65 5 N m (48 4 lb ft).
Open the valves on the auxiliary lines.
Purge the air from the hydraulic system. In order to purge the hydraulic system of air, slowly open the shells (4) and close the shells (4) four times. When you are purging the hydraulic system, do not apply any extra hydraulic pressure to the shells.
In order to purge the hydraulic system of air, slowly rotate the grapple (5) for ten revolutions.