STRAP AS 2855387 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines and on all hoses for installation purposes. Plug all lines and all hoses. This will help to prevent fluid loss and this will help to keep contaminants from entering the system.
Open the engine hood.
Tilt the cab upward. Reference: Operation and Maintenance Manual, SEBU7197, "554 Forwarder and 574 Forwarder", "Cab Tilting"
Illustration 1 g00611976
Turn secondary disconnect switch (1) to the OFF position.
Illustration 2 g00627535
Disconnect five hydraulic lines (2) from bogie float valve (3).
Loosen the screw on electrical connector (5). Unplug electrical connector (5) from bogie float valve (3).
Remove two bolts (4) with washers and the nuts.
Remove bogie float valve (3).