STRAP 3037754 - Caterpillar

Table 1
Required Parts
Qty New Part Number Part Name
1 570-4475 Strainer Plate Gp Rework Procedure
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Illustration 1 g06358933
Filler port location
Illustration 2 g06359921
(A) Strainer
(B) Spacer
Illustration 3 g06359929
(C) Filler port seat
Table 2
Contents of 570-4475 Strainer Plate Gp
Part Number Part Name Description
570-4476 Plate Outside Diameter 90 mm (3.54330 inch)
570-4477 Plate Outside Diameter 90.5 mm (3.56299 inch)
570-4478 Plate Outside Diameter 91 mm (3.58267 inch)
570-4479 Plate Outside Diameter 91.5 mm (3.60236 inch)
570-4480 Plate Outside Diameter 92 mm (3.62204 inch)
Illustration 4 g06358794
Spacer
Note: Remove the strainer and/or spacer from inside the fuel tank if the strainer or spacer dropped into the tank.
Drain the fuel tank.
Illustration 5 g06359203
(1) 349-7059 Fuel Cap As
(2) 505-7091 Sheet As
Illustration 6 g06359205
(3) 513-9097 Fuel Level Sender As
If necessary, remove 505-7091 Sheet As and 513-9097 Fuel Level Sender As.
Use an appropriate tool to remove the strainer and/or spacer from inside the tank.
Install a new 363-4122 Gasket on the fuel level sender. Install 513-9097 Fuel Level Sender As (3). Tighten the 8T-4127 Screws to 3.3 0.7 N m (29.21 6.20 lb in).
Install 505-7091 Sheet As (2). Tighten the 135-8572 Bolts to 25 5 N m (18.4 3.7 lb ft).