STRAP-CABLE 6K0806 - Caterpillar

Caterpillar Products All MachinesGenerator Set AllIntroduction
Table 1
Revision History
Revision Summary of Changes
35 Changes made to update VisionLink Improvements (As of 01 November 2018) This Special Instruction contains information about release notes for VisionLink and VisionLink Store for all Caterpillar Products. Improved VisionLink and VisionLink Store Software is now available for all Caterpillar machines. The new software release contains the changes and improvements listed below.More information regarding VisionLink and VisionLink Store product enhancements are available under the "VisionLink Release Notes" or "VisionLink Store Release Notes" found on the "dealer.cat.com". The Product Link website address is given below:https://dealer.cat.com/pl
Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive.If a tool, a procedure, a work method, or operating technique that is not recommended by Caterpillar is used. Ensure that the tool, procedure, work method, or operating technique is safe to use. Ensure that the product will not be damaged or made unsafe by the operation, lubrication, maintenance, or the repair procedures that are used.VisionLink Improvements (As of 01 November 2018)
The following improvements have been made to VisionLink with recent updates and patches:
Resolved a software issue that prevented new Geofence locations from display the same asset population as a previously generated Geofence for the same area and same asset population.
Corrected an alignment issue with the graph data and legend within the Utilization widget on the dashboard page.
Resolved an issue with the registration and management of assets that have recently changed owner, so that device more promptly associate with the new owner.
Corrected an issue that associated asset status the words with the ON status of the machine. Now asset ON status will be displayed when the asset is running.
Corrected an issue with the advanced filters that would not allow all the filtered devices to be displayed.
Resolved an issue with the setting in preferences that would not change the currency setting.
Corrected the issue that caused the occurrence count for some fault codes to drop to zero when they reached their maximum count number.
Corrected an issue with the report wizard that led to fault code information not being fully reported.
Revised the "Unified Productivity" page to now display loading units in the chart rather than a dash.
Corrected a misalignment issue where white bars would block out some of the totals bars and headers when viewing pinned pages.
Addressed issues in the User Interface (UI) FireFox which