STRAP 8R3393 - Caterpillar

Install adapter (9) in the DPF outlet using a 7W-3556 Washer . Install elbow (10) into the DPF inlet.
Illustration 17 g03317285
(11) 416-4738 Bracket
Illustration 18 g03317288
(12) 294-6118 Pressure Sensor (13) 330-6719 Pressure Sensor Gp (14) 398-3754 Manifold
Assemble the DPF pressure sensor manifold. Install pressure sensor (13) into manifold (14) using a 228-7100 O-Ring Seal . Install delta pressure sensor (12) onto manifold (14) using the following parts: two 6V-4365 O-Ring Seals , one 424-1200 Bracket and six 296-4285 Screws .
Illustration 19 g03317294
Left side view of manifold (14) (15) 030-7942 Elbow
Install elbow (15) into the left side of the sensor manifold (under the connector for the DPF delta pressure sensor) using a 214-7568 O-Ring Seal . Refer to Illustration 19 for the orientation of the new elbow.
Illustration 20 g03317299
(16) 5P-1046 Connector
Install connector (16) into the right side of manifold (14) using a 214-7568 O-Ring Seal .
Illustration 21 g03317301
Assembled sensor manifold installed on bracket (11)
Install the assembled sensor manifold onto bracket (11) using two 5C-9553 Bolts and two 9X-8256 Washers .
Install assembled sensor manifold with bracket (11) using three 242-2961 Spacers , three 7X-2533 Bolts , and three 9X-8256 Washers .
Illustration 22 g03317302
(17) 415-2415 Air Hose (18) 418-3994 Tube As (19) 124-6275 Hose Clamp
Connect the sensor manifold to the DPF inlet using air hose (17), tube (18), and clamps (19) .
Illustration 23 g03317488
(20) 416-4735 Tube As (21) 124-6275 Hose Clamps (22) 416-4736 Tube As (23) 415-2415 Air Hose
Connect the sensor manifold to the DPF outlet using the following parts: tube (20), clamps (21), tube (22) and air hose (23) .
Illustration 24 g03317495
(24) 418-3996 Bracket As (25) 9S-4200 Clip
Install bracket (24) using a 183-7121 Bolt and a 8T-4121 Hard Washer . Install clip (25) to secure the tube to bracket (24) using a 5C-9553 Bolt and a 9X-8256 Washer .
Reconnect the sensor connections at the ARD air pressure sensor, DPF inlet pressure sensor, and DPF delta pressure sensor.
Close the engine hood, then start and warm up engine. Once engine has reached operating temperature, initiate an "ARD Ignition Test" in Caterpillar Electronic Technician (Cat® ET) to verify system performance.Note: system performance is acceptable, rework is complete