1963773 STRIKER Caterpillar parts
D5N, D5R LGP, D6N, D6N LGP
Rating:
Alternative (cross code) number:
CA1963773
196-3773
1963773
CA1963773
196-3773
1963773
Weight: 0.16 pounds 0 kg.
TRACK-TYPE TRACTOR,
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
Information:
The decimal point is not used when reading temperatures above 199.9°C or 199.9°F.Example: A reading of 0.565 = 565°: 1.200 = 1200°. Due to temperature adapter internal limitations, the maximum temperature to be measured should not be more than 900°C (1652°F).3. Plug the connector of the thermocouple probe or wire into the input connection of adapter (1). Do not force the connector into the adapter.To ensure correct polarity for the thermocouple, the connector can only be installed one way. The narrow positive (+) terminal must plug into the left side (narrow slot) of the adapter input connector.Use °C/°F Switch (4) to select the desired temperature reading.4. Move ON/OFF/TEST Switch (3) to the ON position.5. Put the thermocouple tip in contact with the area where temperature is to be measured. Allow a few seconds for the temperature reading on the multimeter to become stabilized.6. Read the temperature displayed on the multimeter (2). When temperature measurement is complete, move ON/OFF/TEST Switch (3) to the OFF position to prolong battery life.Battery Replacement for 6V9129 Temperature Adapter
1. Remove four screws (1). Separate the two halves of case (2), and remove battery (3).2. Install a new heavy duty or alkaline 9 Volt battery.3. Assemble the case; be sure that battery pad (4) and plugs (5) are in their correct position.4. Install and tighten four screws (1).
Battery pad (4) must keep battery (3) separated from printed circuit board (PCB) (6), to prevent possible damage to the temperature adapter.
When connecting a thermocouple connector to the temperature adapter make sure the thermocouple connector is correctly plugged into the adapter. The narrow positive (+) blade of the thermocouple connector must plug into the narrow positive socket (7) of temperature adapter connector (8).Troubleshooting
If the temperature reading becomes erratic or is questionable, make sure the multimeter is working correctly. Then, check the battery voltage of the 6V9129 Temperature Adapter. See 6V9129 TEMPERATURE ADAPTER OPERATION.If the test indicates correct operation of both parts, do the procedure that follows: 1. Inspect the thermocouple to make sure the wire is correctly connected to yellow thermocouple connector (1).2. Remove two screws (2), and lift off cover (3).* Make sure the thermocouple wire with the red insulation jacket is connected to the negative (-) blade terminal. [The negative (-) blade terminal is wider than the positive (+) blade terminal.] The thermocouple wire with the yellow insulation jacket should be connected to the position (+) blade terminal. Be sure the two wires are not touching (shorted) to each other.3. Repair the connections if necessary, then install cover (3) and screws (2).* If additional test, calibration or performance check information is needed, order a Service Manual for a Beckman Model TC-253 Temperature/Voltage Converter. Order Beckman Instructions FG3000-940-133 from the address given at the back of this instruction.8T0458 Thermocouple Wire and/or 6V9131 Thermocouple Probe Repair
With normal use, 8T0458 Thermocouple Wire (1) and 6V9131 Thermocouple Probe (2) should not need service or adjustment. The only repair that can be made to either part is the replacement of
1. Remove four screws (1). Separate the two halves of case (2), and remove battery (3).2. Install a new heavy duty or alkaline 9 Volt battery.3. Assemble the case; be sure that battery pad (4) and plugs (5) are in their correct position.4. Install and tighten four screws (1).
Battery pad (4) must keep battery (3) separated from printed circuit board (PCB) (6), to prevent possible damage to the temperature adapter.
When connecting a thermocouple connector to the temperature adapter make sure the thermocouple connector is correctly plugged into the adapter. The narrow positive (+) blade of the thermocouple connector must plug into the narrow positive socket (7) of temperature adapter connector (8).Troubleshooting
If the temperature reading becomes erratic or is questionable, make sure the multimeter is working correctly. Then, check the battery voltage of the 6V9129 Temperature Adapter. See 6V9129 TEMPERATURE ADAPTER OPERATION.If the test indicates correct operation of both parts, do the procedure that follows: 1. Inspect the thermocouple to make sure the wire is correctly connected to yellow thermocouple connector (1).2. Remove two screws (2), and lift off cover (3).* Make sure the thermocouple wire with the red insulation jacket is connected to the negative (-) blade terminal. [The negative (-) blade terminal is wider than the positive (+) blade terminal.] The thermocouple wire with the yellow insulation jacket should be connected to the position (+) blade terminal. Be sure the two wires are not touching (shorted) to each other.3. Repair the connections if necessary, then install cover (3) and screws (2).* If additional test, calibration or performance check information is needed, order a Service Manual for a Beckman Model TC-253 Temperature/Voltage Converter. Order Beckman Instructions FG3000-940-133 from the address given at the back of this instruction.8T0458 Thermocouple Wire and/or 6V9131 Thermocouple Probe Repair
With normal use, 8T0458 Thermocouple Wire (1) and 6V9131 Thermocouple Probe (2) should not need service or adjustment. The only repair that can be made to either part is the replacement of
Caterpillar parts catalog:
Parts striker Caterpillar catalog:
1293737
STRIKER BOLT-CAB
953C, 963C, 973C, CB-434D, CB-534D, CB-564D, D5N, D5R LGP, D6G, D6N, D6N LGP, D6T, D6T LGP, D6T LGPPAT, D6T XL, D7E, D7E LGP
953C, 963C, 973C, CB-434D, CB-534D, CB-564D, D5N, D5R LGP, D6G, D6N, D6N LGP, D6T, D6T LGP, D6T LGPPAT, D6T XL, D7E, D7E LGP
1688929
STRIKER AS
D5N, D5R LGP, D6G, D6N, D6N LGP
D5N, D5R LGP, D6G, D6N, D6N LGP
2095528
STRIKER
938H, 950H, 950K, 962H, 962K, 966F II, 966G II, 966H, 966K, 972G II, 972H, 972K, 980C, D6N, IT38H, IT62H
938H, 950H, 950K, 962H, 962K, 966F II, 966G II, 966H, 966K, 972G II, 972H, 972K, 980C, D6N, IT38H, IT62H
1688929
STRIKER AS
D5N, D5R LGP, D6G, D6N, D6N LGP
D5N, D5R LGP, D6G, D6N, D6N LGP
6Y4088
STRIKER AS
D6R, D6R II, D8N, D8R
D6R, D6R II, D8N, D8R
1293737
STRIKER BOLT-CAB
953C, 963C, 973C, CB-434D, CB-534D, CB-564D, D5N, D5R LGP, D6G, D6N, D6N LGP, D6T, D6T LGP, D6T LGPPAT, D6T XL, D7E, D7E LGP
953C, 963C, 973C, CB-434D, CB-534D, CB-564D, D5N, D5R LGP, D6G, D6N, D6N LGP, D6T, D6T LGP, D6T LGPPAT, D6T XL, D7E, D7E LGP
6V5158
STRIKER AS-BODY
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14G, 14H, 14H NA, 160H, 160H ES, 160H NA, 160K, 163H, ...
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14G, 14H, 14H NA, 160H, 160H ES, 160H NA, 160K, 163H, ...
3W1547
STRIKER AS
D10R, D10T2, D11R, D11T, D6H, D6H XL, D6H XR, D8R, D8R II, D8T, D9R, D9T
D10R, D10T2, D11R, D11T, D6H, D6H XL, D6H XR, D8R, D8R II, D8T, D9R, D9T
2955742
STRIKER AS
953D, 963D, 973D
953D, 963D, 973D
2669306
STRIKER AS
D6K, D6K LGP, D6K XL, D6K2, D6K2 LGP
D6K, D6K LGP, D6K XL, D6K2, D6K2 LGP
2669307
STRIKER AS
D6K, D6K LGP, D6K XL, D6K2, D6K2 LGP
D6K, D6K LGP, D6K XL, D6K2, D6K2 LGP
2817631
STRIKER
770G, 770G OEM, 772G, 772G OEM, 773G, 773G LRC, 773G OEM, 775G, 775G LRC, 775G OEM, 777G, 824K, 825K, 826K, 836K, D3K XL, D4K XL, D5K LGP, D6K, D6K LGP, D6K XL, PL61
770G, 770G OEM, 772G, 772G OEM, 773G, 773G LRC, 773G OEM, 775G, 775G LRC, 775G OEM, 777G, 824K, 825K, 826K, 836K, D3K XL, D4K XL, D5K LGP, D6K, D6K LGP, D6K XL, PL61
2643011
STRIKER AS
D3K XL, D3K2 LGP, D4K XL, D4K2 XL, D5K LGP, D5K2 XL, D6K LGP, D6K2, D6K2 LGP
D3K XL, D3K2 LGP, D4K XL, D4K2 XL, D5K LGP, D5K2 XL, D6K LGP, D6K2, D6K2 LGP
2399961
STRIKER AS
583T, 587R, 587T, D10T, D10T2, D11T, D8T, D9T, PL83, PL87
583T, 587R, 587T, D10T, D10T2, D11T, D8T, D9T, PL83, PL87
1803129
STRIKER
D3G, D4G, D5G, D6G, D6G2 LGP, D6G2 XL
D3G, D4G, D5G, D6G, D6G2 LGP, D6G2 XL