STRIKER AS 2129428 - Caterpillar

Directional and Steering Controls
Normal steering is when the final drive sprockets are under the rear of the machine. Idlers are under the front of the cab. Reverse steering is when the cab is over the sprockets. Both the directional and steering functions will be reversed. Always travel with sprockets under the rear of the machine.The farther the levers are pushed forward or pulled backward, the faster the travel speed.The farther the pedal is pushed at the toe or heel side, the faster the travel speed. The travel alarm (if equipped) is located behind the hydraulic tank. This alarm will sound when the travel lever or pedal is activated. Reverse Direction Travel Levers (1) - Pull back on both levers at the same time and distance for reverse travel. Reverse Direction Travel Pedals - Push both pedals at the heel, at the same time.The machine will always travel toward the sprockets. Brakes On (2) - Release both of the directional travel control levers or pedals to apply the brakes. Forward Direction Travel Levers (3) - Push forward on both levers at the same time and distance for forward travel. Forward Direction Travel Pedals - Push both pedals on the toe, at the same time.The machine will always travel toward the idlers. The farther the levers or pedals are moved forward or backward, the faster the turning speed. Use the pedals as well as the levers to make turns. Spot Left Turn (4) - Pull backward on the left lever and push forward on the right lever at the same time. This allows a quick left turn (counter track rotation). Pivot Left Turn - Push forward on the right lever, allowing the machine to turn to the left pivoting on the left track. Spot Right Turn (5) - Pull backward on the right lever and push forward on the left lever at the same time, allowing a quick right turn (counter track rotation). Pivot Right Turn - Push forward on the left lever, allowing the machine to turn to the right, pivoting on the right track.Governor Control Lever (5TG1 to 00234)
Governor Control Lever - Controls the engine speed (rpm). Increase (1) - Move lever back to increase the engine speed. Decrease (2) - Move lever forward to decrease the engine speed. Engine Shut Off (3) - Move lever fully forward, past low idle detent, to stop the engine.Governor Control Lever (5TG 00235-up)
Governor Control Lever - Controls the engine speed (rpm). Increase (1) - Move lever back to increase the engine speed. Decrease (2) - Move lever forward to decrease the engine speed.Power Mode Switch
Power Mode Switch - Used to change the power mode of the machine. Selects a suitable power mode position from the three positions, depending on type of working conditions or purposes. The digging force does not vary in any modes. ... Suitable for heavy duty work which needs higher operating speed. Turning this switch to this position provides the maximum power of the machine. ...