8E4832 STRIKER Caterpillar parts
587R, 587T, D6G2 LGP, D6G2 XL, D6H, D6H II, D6H XL, D6H XR, D6R, D6R II, D6R III, D6R STD, D6T, D6T LGP, D6T LGPPAT, D6T XL, D7E, D7E LGP, D7G, D7G2, D8T, D9T, PL87
Rating:
Alternative (cross code) number:
CA8E4832
8E-4832
8E4832
CA8E4832
8E-4832
8E4832
Weight: 0.22 pounds 0 kg.
PIPELAYER, TRACK-TYPE TRACTOR,
Compatible equipment models: 8E4832:
Information:
MID 039 CID 0262 FMI 03Conditions Which Generate This Code:
Illustration 1 g01343715
Connections of the 5 Volt Supply
The sensor supply is a power supply that is internal to the ECM. The sensor supply provides +5 DCV in order to operate the sensors.This diagnostic code will be recorded when the ECM reads the voltage for the circuit of the sensor supply as being above normal.The results of this diagnostic code are listed:
All of the associated sensors will also log diagnostic codes.The possible causes of the diagnostic code are listed:
+5 DCV (wire R997-OR(Orange)) is shorted to the +battery circuit in the machine harness.
The ECM has failed. This is unlikely.Test Step 1. CHECK FOR SHORT TO THE +BATTERY CIRCUIT
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness from the ECM.
At the machine harness connectors for the ECM, measure the resistance between the +battery contact and the contact for the sensor supply voltage. See the schematic for more detailed information about the sensor power supply for the sensor that is being tested. Expected Result:The resistance that is measured should be greater than 5000 ohms.Results:
OK - The resistance is greater than 5000 ohms. The harness circuit is correct. The ECM has failed.Repair: It is unlikely that the ECM has failed. Perform this procedure again. Prior to replacing an ECM, always contact your dealership for possible consultation with Caterpillar. This consultation may greatly reduce repair time. If the ECM requires replacing, refer to Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP
NOT OK - The resistance measures less than 5000 ohms. The machine harness has failed. There is a short between the +battery circuit and the circuit for the sensor power supply in the machine harness.Repair: Repair the machine harness or replace the machine harness. STOP
Illustration 1 g01343715
Connections of the 5 Volt Supply
The sensor supply is a power supply that is internal to the ECM. The sensor supply provides +5 DCV in order to operate the sensors.This diagnostic code will be recorded when the ECM reads the voltage for the circuit of the sensor supply as being above normal.The results of this diagnostic code are listed:
All of the associated sensors will also log diagnostic codes.The possible causes of the diagnostic code are listed:
+5 DCV (wire R997-OR(Orange)) is shorted to the +battery circuit in the machine harness.
The ECM has failed. This is unlikely.Test Step 1. CHECK FOR SHORT TO THE +BATTERY CIRCUIT
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness from the ECM.
At the machine harness connectors for the ECM, measure the resistance between the +battery contact and the contact for the sensor supply voltage. See the schematic for more detailed information about the sensor power supply for the sensor that is being tested. Expected Result:The resistance that is measured should be greater than 5000 ohms.Results:
OK - The resistance is greater than 5000 ohms. The harness circuit is correct. The ECM has failed.Repair: It is unlikely that the ECM has failed. Perform this procedure again. Prior to replacing an ECM, always contact your dealership for possible consultation with Caterpillar. This consultation may greatly reduce repair time. If the ECM requires replacing, refer to Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP
NOT OK - The resistance measures less than 5000 ohms. The machine harness has failed. There is a short between the +battery circuit and the circuit for the sensor power supply in the machine harness.Repair: Repair the machine harness or replace the machine harness. STOP
Cat SIS web machinery list:
Parts striker Caterpillar catalog:
2566020
STRIKER GP-REAR
D6R III, D6T, D6T LGP, D6T LGPPAT, D6T XL
D6R III, D6T, D6T LGP, D6T LGPPAT, D6T XL
1Z0685
STRIKER GP-FRONT
D6R, D6R II
D6R, D6R II
2963830
STRIKER GP
D6G2 LGP, D6G2 XL
D6G2 LGP, D6G2 XL
2007019
STRIKER GP-REAR
D6R, D6R II
D6R, D6R II
2655211
STRIKER GP-REAR
D6R III, D6T, D6T LGP, D6T LGPPAT, D6T XL
D6R III, D6T, D6T LGP, D6T LGPPAT, D6T XL
6V1155
STRIKER AS
215, 215B, 215C, 215D, 225, 227, 229, 235, 235B, 235C, 2384C, 245, 2484C, 30/30, 508, 517, 518, 518C, 527, 528B, 530B, 539, 559C, 579C, 613C, 615, 615C, 65, 65C, 65E, 69D, 75, 75C, 75D, 75E, 769C, 769...
215, 215B, 215C, 215D, 225, 227, 229, 235, 235B, 235C, 2384C, 245, 2484C, 30/30, 508, 517, 518, 518C, 527, 528B, 530B, 539, 559C, 579C, 613C, 615, 615C, 65, 65C, 65E, 69D, 75, 75C, 75D, 75E, 769C, 769...
5V8309
STRIKER AS
215, 215B, 216, 216B, 216B3, 225, 225D, 226B, 226B3, 227, 228, 229, 229D, 231D, 232B, 235, 235B, 235C, 235D, 236, 236B, 236B3, 242B, 245, 245B, 245D, 246C, 247, 247B, 247B3, 248, 252B, 252B3, 256C, 25...
215, 215B, 216, 216B, 216B3, 225, 225D, 226B, 226B3, 227, 228, 229, 229D, 231D, 232B, 235, 235B, 235C, 235D, 236, 236B, 236B3, 242B, 245, 245B, 245D, 246C, 247, 247B, 247B3, 248, 252B, 252B3, 256C, 25...
8T3848
STRIKER AS-LATCH
216, 216B, 216B3, 226B, 226B3, 228, 232B, 236, 236B, 236B3, 242B, 242B3, 247, 247B, 247B3, 248, 252B, 252B3, 257B, 257B3, 259B3, 267, 267B, 268B, 287, 30/30, 517, 527, 611, 613C II, 615C, 769D, 771D, ...
216, 216B, 216B3, 226B, 226B3, 228, 232B, 236, 236B, 236B3, 242B, 242B3, 247, 247B, 247B3, 248, 252B, 252B3, 257B, 257B3, 259B3, 267, 267B, 268B, 287, 30/30, 517, 527, 611, 613C II, 615C, 769D, 771D, ...
4Z8984
STRIKER AS
D7R, D7R II, D8R, D8R II, D8T
D7R, D7R II, D8R, D8R II, D8T
4Z8985
STRIKER AS
D7R, D7R II, D8R, D8R II, D8T
D7R, D7R II, D8R, D8R II, D8T
2746490
STRIKER
D7G2
D7G2
8Y8304
STRIKER AS-LATCH
611, 613C II, 615C, AD30, AD45B, AD55, AD55B, AD60, D5M, D6M, D6R, D6R II, D7R, D7R II, D7R XR, D8R
611, 613C II, 615C, AD30, AD45B, AD55, AD55B, AD60, D5M, D6M, D6R, D6R II, D7R, D7R II, D7R XR, D8R
0996624
STRIKER
307, E110, E110B, E120, E120B, E140, E180, E200B, E240, E240C, E300, E300B, E450, E70, E70B, EL240B
307, E110, E110B, E120, E120B, E140, E180, E200B, E240, E240C, E300, E300B, E450, E70, E70B, EL240B
0938584
STRIKER
307, E110, E110B, E120, E120B, E140, E180, E200B, E240, E240C, E300, E300B, E450, E650, E70, E70B, EL240B
307, E110, E110B, E120, E120B, E140, E180, E200B, E240, E240C, E300, E300B, E450, E650, E70, E70B, EL240B
0938583
STRIKER
307, E110, E110B, E120, E120B, E140, E180, E200B, E240, E240C, E300, E300B, E450, E650, E70, E70B, EL240B
307, E110, E110B, E120, E120B, E140, E180, E200B, E240, E240C, E300, E300B, E450, E650, E70, E70B, EL240B
5W5339
STRIKER
205, 206, 212
205, 206, 212
6Y4088
STRIKER AS
D6R, D6R II, D8N, D8R
D6R, D6R II, D8N, D8R
1293737
STRIKER BOLT-CAB
953C, 963C, 973C, CB-434D, CB-534D, CB-564D, D5N, D5R LGP, D6G, D6N, D6N LGP, D6T, D6T LGP, D6T LGPPAT, D6T XL, D7E, D7E LGP
953C, 963C, 973C, CB-434D, CB-534D, CB-564D, D5N, D5R LGP, D6G, D6N, D6N LGP, D6T, D6T LGP, D6T LGPPAT, D6T XL, D7E, D7E LGP
6V5158
STRIKER AS-BODY
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14G, 14H, 14H NA, 160H, 160H ES, 160H NA, 160K, 163H, ...
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14G, 14H, 14H NA, 160H, 160H ES, 160H NA, 160K, 163H, ...
3W1547
STRIKER AS
D10R, D10T2, D11R, D11T, D6H, D6H XL, D6H XR, D8R, D8R II, D8T, D9R, D9T
D10R, D10T2, D11R, D11T, D6H, D6H XL, D6H XR, D8R, D8R II, D8T, D9R, D9T
2955742
STRIKER AS
953D, 963D, 973D
953D, 963D, 973D
2967726
STRIKER AS
D6R, D6R II, D6R III, D6R STD, D6T, D6T LGP, D6T XL, D7R II, D7R XR, D8R, D8R II
D6R, D6R II, D6R III, D6R STD, D6T, D6T LGP, D6T XL, D7R II, D7R XR, D8R, D8R II