STRIP-WEAR 2574939 - Caterpillar

Put lubricant on the lip of all seals. Put 5P960 Grease on all pin bores (lift and tilt cylinders, bucket and frame pin bores).(10) Torque for six bolts ... 270 25 N m (200 18 lb ft)Installation Procedure for Pin Assemblies (9).
The pin assemblies are made up of pins (9), sleeve bearings (20), thrust bearings (25), the seals and seal retainers.1. Clean the bores for all pin assemblies (9) and collets (21).2. Install pin assemblies (9) through lift arm assembly (19) and bucket (27). Make sure that plugs (22) and (26) are toward the top.3. Tighten bolts (10) to a torque of 270 25 N m (200 18 lb ft)4. Remove plugs (22) and (26). Put 5P7504 Pin Lube Oil into the hole where plug (26) was removed. When oil comes out the hole where plug (22) was removed, install plugs (22) and (26).5. Put 5P3931 Anti-Seize Compound on collets (21) and threads of bolts (24).6. Install collets (21), washers (23) and bolts (24).7. Tighten bolts (24) to a torque of 875 100 N m (640 75 lb ft). After the bolts are tight, hit collets (21) with a heavy hammer so the torque for bolts (24) is less than 465 N m (345 lb ft). Tighten bolts (24) again to a torque of 875 N m (640 lb ft). Hit each collet again so the torque for bolts (24) is less than 700 N m (520 lb ft). Tighten bolts (24) to a final torque of 875 100 N m (640 75 lb ft).