STRIP-FILLER 2U1675 - Caterpillar

Required Tools
Table 1
Required Tools
Description Qty
Measuring Tape 1
Stopwatch 1 Test Procedure - 568 GF
Illustration 1 g00298378Position the machine on level ground. Empty the bucket. Refer to Illustration 1.Boom Cylinder Head End, Stick Cylinder Rod End, and Bucket Cylinder Head End
Fully extend the bucket cylinder.
Fully retract the stick cylinder.
Extend the stick cylinder rod 70 mm (2.8 inch) from the fully retracted position.
Illustration 2 g01402004
Raise the boom until the stick to bucket pin is the same height as the boom foot pin. Refer to Illustration 2.
Measure the length of each cylinder from cylinder pin to cylinder pin.
Stop the engine.
Leave the machine in this position for 5 minutes. Measure the length of each cylinder from cylinder pin to cylinder pin for drift. Stick Cylinder Head End
Start the engine.
Fully extend the bucket cylinder.
Fully extend the stick cylinder.
Retract the stick cylinder rod 60 mm (2.4 inch) from the fully extended position.
Illustration 3 g01401745
Raise the boom until the stick to bucket pin is 600.0 mm (23.6 inch) high from ground level. Refer to Illustration 3.
Measure the length of the stick cylinder from cylinder pin to cylinder pin.
Stop the engine.
Leave the machine in this position for 5 minutes. Measure the length of the stick cylinder from cylinder pin to cylinder pin for drift. Bucket Cylinder Rod End
Start the engine.
Fully retract the bucket cylinder.
Fully retract the stick cylinder.
Illustration 4 g01401747
Raise the boom until the stick to bucket pin is 600.0 mm ( 23.6 inch) high from ground level. Refer to Illustration 4.
Measure the length of the bucket cylinder from cylinder pin to cylinder pin.
Stop the engine.
Leave the machine in this position for 5 minutes. Measure the length of the bucket cylinder from cylinder pin to cylinder pin for drift. Test Procedure - 568 LL
Illustration 5 g01708035
Position the machine on level ground. Refer to Illustration 5.
Fully extend the heel cylinder.
Fully retract the stick cylinder.
Retract the stick cylinder rod 70 mm (2.8 inch) from the fully extended position.
Raise the boom until the stick to heel pin is the same height as the boom foot pin. Refer to Illustration 5.
Measure the length of each cylinder from cylinder pin to cylinder pin.
Stop the engine.
Leave the machine in this position for 5 minutes. Measure the length of each cylinder from cylinder pin to cylinder pin for drift. Worksheet
Table 2
"Cylinder Drift - Check (Empty Bucket)"
Date Machine Serial Number
Sales Model Item Cylinder Position Cylinder Drift mm (inch) Actual
568 GF Boom Cylinder Extended 4.5 mm (0.18 inch) or less
Stick Cylinder Retracted 10.0 mm (0.39 inch) or less
Extended 25.0 mm (0.98 inch) or less
Bucket Cylinder Extended 10.0 mm (0.39 inch) or less
Retracted 20.0 mm (0.79 inch) or less
568 LL Boom Cylinder Extended 4.5 mm (0.18 inch) or less
Stick Cylinder Retracted N/A
Extended 10.0 mm (0.39 inch) or less
Heel Cylinder Extended N/A
Retracted 10.0 mm (0.39 inch) or less