STRIP 5054318 - Caterpillar

Table 2
TRAVEL TIME (SPEED) FOR THE LIFT CYLINDERS    
Position of the Hydraulic Control     252/ 262    
RAISE     4.8 0.2 seconds    
LOWER     3.4 0.2 seconds    
FLOAT     3.6 0.2 seconds    If the speeds are not correct, refer to the Testing and Adjusting, "Hydraulic System Troubleshooting".Tilt Cylinder Speed Test
Note: Perform the tilt cylinder speed test with an empty general purpose bucket. If a general purpose bucket is not available, then use a load weight of 200 kg (441 lb).
Fasten the seat belt and lower the armrest.
Start the engine.
Disengage the parking brake.
Run the engine at high idle with the pilot operated hydraulic control ( hydrostatic) in the HOLD position.
Operate the