STRIP-WEAR 5T8367 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 366-3469 Mounting Bar 2
B - Guide Stud
5/8 - 11 by 12 inch 8
8T-4122 Hard Washer 8
6V-4803 Thrust Bearing 8
4K-0367 Full Nut 16
C 4C-5591 Anti-Seize Compound -
F 366-3468 Cover Plate 6
G 2D-7325 Pipe Tee 3
8T-0853 Pressure Gauge 3
4C-7121 Nipple 3
129-3078 Shutoff Valve Assembly 3
4C-7158 Fitting 3
5P-3413 Pipe Sealant -
H 4C-7121 Nipple 3
129-3078 Shutoff Valve Assembly 3
4C-7000 Bushing 3
7W-8705 Fitting 3
5P-0720 Hose 1
5P-3413 Pipe Sealant - Note: The following story is for 300-5617 Sea Water Heat Exchanger Gp.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g02130836
Install liners (8) and collars (7) in the ports of the rear frame.Note: The liners are installed through the rear of the rear frame.
Illustration 2 g06097989
Illustration 3 g02146927
Position gasket (9) on the heat exchanger plate (6). Install tabs (X) of the gasket into the slots of heat exchanger plate (6). Install ring seals (10) into the grooves of first heat exchanger plate.Note: Use tape to hold ring seal (10) in the grooves of the first heat exchanger plate.
Illustration 4 g06097990
Install gaskets (9) onto the rest of the heat exchanger plates (6).
Illustration 5 g02141318
Illustration 6 g02105674
(A) Rear frame
(B) Front of the engine
(J) 327-1133 Plate Assembly
(K) 327-1134 Plate Assembly
(L) 327-1136 Plate Assembly