STRIP 7N2415 - Caterpillar

Illustration 4 g01442164
Remove O-ring seal (6) from yoke (5).
Remove yoke (5) from the front drive shaft. The yoke is a slip fit to the drive shaft. Note: Be sure to mark the orientation of yoke (5) to the front drive shaft before removal.
Illustration 5 g01441399
Rear View
Illustration 6 g01441405
Front View
Remove bolts (7), the washers, and nuts (9) that fasten carrier bearing housing (8) to the front frame.
Illustration 7 g01441404
Install Tooling (B) in the threaded holes of carrier bearing housing (8). Tighten Tooling (B) evenly in order to free carrier bearing housing (8) from the front loader frame.
Illustration 8 g01441407
Attach Tooling (C) and a suitable lifting device to carrier bearing housing (8) and to the front drive shaft.
Use Tooling (C) and the suitable lifting device in order to remove carrier bearing housing (8) from the drive shaft. The weight of carrier bearing housing (8) is approximately 50 kg (110 lb).
Illustration 9 g00352991
Illustration 10 g00353034
Use Tooling (A) and the suitable lifting device in order to carefully lower front drive shaft (1) to the ground. The weight of front drive shaft (1) is approximately 102 kg (225 lb).
Illustration 11 g01441594
Remove bolts (10), bearing retainer (11), and bearing spacer (12) from carrier bearing housing (8).
Illustration 12 g01441603
Remove O-ring seal (13) from carrier bearing housing (8).
Illustration 13 g01441615
Illustration 14 g01441856
Use Tooling (D) in order to remove lip seal (14) from bearing retainer (11).
Illustration 15 g01441859
Illustration 16 g00353202
Position carrier bearing housing (8) onto suitable cribbing. Use a suitable hammer and a suitable punch in order to remove bearing cups (15) and bearing cones (16).
Illustration 17 g01441863
Illustration 18 g01441622
Use Tooling (D) in order to remove lip seal (17) from carrier bearing housing (8).