STRIP 8Y1853 - Caterpillar

Removal Procedure
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01372468
Disconnect harness assembly (1). Disconnect harness assembly (2) .
Illustration 2 g01372473
Remove flame detection temperature sensor (3) .
Illustration 3 g01372474
Remove flame detection temperature sensor (4) .Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     5P-3931     Anti-Seize Compound     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 4 g01372474
Apply Tooling (A) to the threads of flame detection temperature sensor (4) .
Install flame detection temperature sensor (4). Tightenflame detection sensor (4) to a torque of 45 5 N m (33 4 lb ft).
Illustration 5 g01372473
Apply Tooling (A) to the threads of flame detection temperature sensor (3) .
Install flame detection temperature sensor (3). Tighten flame detection temperature sensor (3) to a torque of 45 5 N m (33 4 lb ft).
Illustration 6 g01372468
Connect harness assemblies (2) and (1) .