STRIP 9S1046 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.An authorized operator may perform the maintenance items with daily intervals. An authorized operator may perform the maintenance items with intervals of every week. The maintenance that is recommended for all other maintenance intervals must be performed by an authorized service technician or by your Cat dealer.The user is responsible for the performance of all maintenance which includes the following items: performing all adjustments, using proper lubricants, fluids, and filters and replacing old components with new components due to normal wear and aging .Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Choose the interval that occurs first in order to determine the correct maintenance interval: fuel consumption, service hours and calendar time . Products that operate in severe operating conditions may require more frequent maintenance. All of the following will affect the oil change interval: operating conditions, fuel type, oil type and size of the oil sump . Scheduled oil sampling analyzes used oil in order to determine if the oil change interval is suitable for your specific engine. Refer to this Operation and Maintenance Manual, "Engine Oil and Filter - Change" in order to determine the oil change interval that is suitable for your specific engine.To determine the maintenance intervals for the overhauls, refer to this Operation and Maintenance Manual, "Maintenance Recommendations" .Unless other instructions are provided, perform maintenance and perform repairs under the following conditions:The starting system is disabled.The engine is stopped.The generator does not pose an electrical shock hazard.The generator is disconnected from the load.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Circuit Breakers - Reset
Engine - Clean
Fuel System - Prime
Generator - Dry
Generator Set - Test
Generator Set Alignment - Check
Generator Winding - Test
Varistor - Inspect
Daily
Control Panel - Inspect/Test
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Fuel Tank Water and Sediment - Drain
Generator Bearing Temperature - Test/Record
Generator Load - Check
Power Factor - Check
Walk-Around Inspection
Every Week
Automatic Start/Stop - Inspect
Battery Charger - Check
Electrical Connections - Check
Generator - Inspect
Generator Lead - Check
Stator Winding Temperature - Test
Voltage and Frequency - Check
Initial 250 Service Hours
Engine Valve Lash - Check
Fuel Injector - Inspect/Adjust/Replace
Every 250 Service Hours
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Protective Devices - Check
Fan Drive Bearing - Lubricate
Fuel System Secondary Filter - Replace
Heat Shield - Check/Replace
Hoses and Clamps - Inspect/Replace
Radiator