STRUT-GAS 2035393 - Caterpillar

Illustration 1 g02184253
The standard line and Accugrade line are located inside of the front access door behind the cab.
Illustration 2 g02184297
Cut the Strap-Cable. Remove the standard line (A) and Accugrade line (B). Refer to Illustration 2.
Illustration 3 g02185140
Install standard lines on (C) position. Install 174-3016 Connector Plug As on connector (D). Install 134-2540 Resistor As on connector (E) for Accugrade line. Fix it on standard line with a Strap-Cable. Refer to Illustration 3Rework Procedure for Accugrade for 320D to 336D With ROPS
The accugrade system might not operate correctly if the machine is equipped with Accugrade when the software of Accugrade or MECM is updated. Remove the CAN connector according to the following procedure when failure occurs. Connect the CAN connector only when you update the software of Accugrade with ET. Parts added by removing the CAN connector are shown in Table 1.
Table 2
No.    Qty    Part Number    Part Name    
1     1     174-3016     Connector Plug As    
2     1     134-2540     Resistor As    
Illustration 4 g02184253
The standard line and Accugrade line are located inside of the front access door at the rear of the cab.
Illustration 5 g02185281
Cut the Strap-Cable. Remove the standard line (A) and Accugrade line (B). Refer to Illustration 5
Illustration 6 g02185314
Install the 174-3016 Connector Plug As on the connector (C) for standard line. Fix Accugrade line on (D) position with Strap-Cable. Install the 134-2540 Resistor As on the connector (E) for Accugrade line. Refer to Illustration 6.Rework Procedure for Accugrade for the 320D RR to 320D LRR Without ROPS and With ROPS
The accugrade system might not operate correctly if the machine is equipped with Accugrade when the software of Accugrade or MECM is updated. Remove the CAN connector according to the following procedure when failure occurs. Connect the CAN connector only when you update the software of Accugrade with ET. Parts added by removing the CAN connector are shown in Table 1.
Table 3
No.    Qty    Part Number    Part Name    
1     1     174-3016     Connector Plug As    
2     1     134-2540     Resistor As    
Illustration 7 g02184253
The standard line and Accugrade line are located inside of the front access door at the rear of the cab.
Illustration 8 g02187795
Cut the Strap-Cable. Remove the standard line (A) and Accugrade line (B). Refer to Illustration 8.
Illustration 9 g02187797
Install the standard line on (C) position. Install the 174-3016 Connector Plug As on the connector (D)