STUD 5I5014 - Caterpillar

Remove ten bolts (4), ten washers (5) and ten spacers (6). Remove two bolts (9), two washers (5), and two spacers (8). The bolts hold track frame (3) to carbody (2) .Note: When you move track frame (3) in order to retract the overall width, do not loosen four bolts (7) that are for the guide.
Illustration 4 g00985169
Remove shields (11) and (12) .
Illustration 5 g01177815
Start the engine. Apply downward pressure with the boom in order to raise the track approximately 51 mm (2 inch) above ground level.
Slowly run the raised track at a low idle. This will cause the raised track to slide toward the center of the machine. The full sliding distance should be 140 mm (5.5 inch).
After the raised track frame has been correctly retracted, lower the track frame to the ground.
Illustration 6 g00975490
(2) Carbody (3) Track frame (4) Bolts (5) Washers (6) Spacers (7) Bolt (8) Spacer (9) Bolt (10) Spacer
Align the bolt holes of carbody (2) and track frame (3). Install two bolts (9), two washers (5) and two spacers (9). Tighten bolts to