SUPPORT-TRUNNION 1014851 - Caterpillar

19. Instal first and second shift lugs (33) and third and fourth shift lugs (34). Tighten Allen locking nut (32) on each of the lugs to a torque of 18 to 24 N m (13 to 18 lb ft). 20. Using a suitable depth gauge, measure the depth of the bearing race from the case. Add .12 mm (.005 in) to this figure. Select a suitable shim so that the shaft end play is .025 to .076 mm (.001 to .003 in). 21. Repeat step 20 for output shaft (15). 22. Install required shims (35) that are needed for steps 20 and 21. 23. Install seal (36) in cover (37). 24. Install a new gasket and install cover (37) onto the transmission case. Install eleven bolts (38) and tighten to a torque of 44 to 64 N m (33 to 47 lb ft). 25. Install O-ring (39) onto the lower seat (40) of stub lever (41). Install a new gasket between housing and upper seat (42). Install upper seat (42) and three bolts (43) to secure upper seat. Tighten three bolts (43) to a torque of 18 to 31 N m (13 to 23 lb ft). 26. Install detent ball (44), spring (45) and plug (46). Install new O-ring on plug (46). Tighten plug (46) to a torque of 40 to 54 N m (30 to 40 lb ft). 27. Install suction strainer O-ring (47), washer (49) and retaining plate (48). Secure with bolts (47) and tighten to a torque of 18 to 31 N m (13 to 23 lb ft). 28. Install a new gasket and 7M7260 Gasket Maker and install oil filter housing (51). Secure with two bolts (52) and tighten to a torque of 45 to 64 N m (33 to 47 lb ft). 29. Install a new gasket and 7M7260 Gasket Maker and install four wheel drive unit (53) and secure with four bolts (54). Tighten bolts (54) to a torque of 45 to 64 N m (33 to 47 lb ft). 30. Install a new gasket and 7M7260 Gasket Maker and install control valve unit (55) and secure with five bolts (56). Tighten bolts to a torque of 31 to 41 N m (23 to 30 lb ft). 31. Install oil drain plug (57) and tighten to a torque of 34 to 54 N m (25 to 40 lb ft). 32. Install output coupling (58). Use care not to destroy or damage the new oil seal. Assemble the transmission control valve as follows: This control valve is used on the following models and serial numbers: 416B 8SG1-UP, 8ZK1-UP, 426B 5YJ1-UP, 6KL1-UP 428B 7EJ1-UP 436B 6MJ1-UP, 7FL1-UP 438B 3KK1-UP. Prior to assembly, replace all old oil seals and gaskets with new. 1. Install spring (18) and ball (19) into hole in selector assembly.2. Install new seal (17) on selector assembly (16) and install selector assembly while holding detent ball back.3. After selector assembly is in position and working properly, install snap ring (15). 4.