SUPPORT-EDGE 1326259 - Caterpillar

Use caution to avoid possible personal injury when adjusting the implement lift kickout.Keep personnel off the machine. Clear the area when working under or around the implement linkage.With the implement raised, proper support must be provided for the implement and/or the linkage.
Illustration 1 g00444723
Lift Kickout (1) Bolts. (2) Plate. (3) Switch assembly. (4) Bolts. (5) Magnet assembly.
Raise the bucket to the desired height while the engine is running. Move the lift control lever to the HOLD position.
Stop the engine.
Loosen two bolts (1) in plate (2) while the electric switch is in the OFF position. Move magnet assembly (5) upward from switch assembly (3) .
Move the electric switch to the ON position. Move the lift control lever until the detent roller will keep the lever in the RAISE position.
Move magnet assembly (5) toward the switch assembly until the lift control lever moves to the HOLD position. Tighten bolts (1) .
Measure the distance between the face of magnet assembly (5) and the face of switch assembly (3). The distance should be 8 2 mm (0.32 0.08 inch).
In order to change the distance, slightly loosen bolts (4). Adjust switch assembly (3) until a gap of 8 2 mm (0.32 0.08 inch) is obtained. Tighten bolts (4) .
Start the engine. Run the engine. The lift kickout must move the lift control lever from the RAISE position to the HOLD position at the moment before the lift arm assembly achieves the top point of travel.
If the kickout occurs too soon, move magnet assembly (1) upward from switch assembly (4). If the kickout occurs too late, move the magnet assembly downward toward the switch assembly.