SUPPORT GP-TRANSMISSION 2018613 - Caterpillar

Start By:a. remove final drives and steering clutches and brakes 1. Remove O-ring seal (1) from the face of the steering clutch and brake. 2. Install tooling (A) on the steering clutch and brake as shown, and fasten a hoist. 3. Remove three bolts (4) that hold steering clutch and brake (2) to final drive (3). Remove steering clutch and brake (2) from final drive (3). The weight of the steering clutch and brake is approximately 388 kg (855 lb.). 4. Turn the steering clutch and brake over. Remove O-ring seal (5). The following steps are for the connection of the final drives and steering clutches and brakes.5. Inspect the O-ring seals for damage, and make replacements if needed. Put clean oil on the O-ring seals.6. Put O-ring seal (5) in position on steering clutch and brake (2).7. Install tooling (A) on the steering clutch and brake, and fasten a hoist. Put steering clutch and brake (2) in position on final drive (3).8. Install three bolts (4) that hold the steering clutch and brake to the final drive.9. Install O-ring seal (1) on the face of the steering clutch and brake.End By:a. install final drives and steering clutches and brakes