SUPPORT AS 2348978 - Caterpillar

Illustration 1 g02301619
Table 1
Specification for Bucket Linkage Gp
Item Qty Part Specification Description
- All bores must be free of paint. Use 5P-0960 Grease Cartridge in order to coat all the pin bores and the bushings before assembly. After you assemble the bushings coat all the bores and the bushings with 5P-0960 Grease Cartridge.
- - - Position the nut (3) to the distance of 0.5 0.5 mm (0.02 0.02 inch) past the end of the bolt (1). For locking, tighten the nut (2) against the nut (3).
4 1 234-3930 Pin Diameter is 89.85 0.04 mm (3.537 0.002 inch).
5 6 166-1495 Lip Type Seal Lubricate the sealing lip of lip type seals lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces the outside, as shown. Install lip type seals so that lip of the lip type seals do not extend beyond the face of the boss.
6 2 228-5615 Bushing Bore before assembly is 90.21 0.04 mm (3.552 0.002 inch).
Installation depth is 13.6 0.3 mm (0.54 0.01 inch).
7 4 451-2184 Nut Torque to 325 40 N m (240 30 lb ft).
8 1 186-5662 Pin Diameter is 69.850 0.040 mm (2.7500 0.0016 inch).
9 2 234-3931 Pin As Diameter is 89.85 0.04 mm (3.537 0.002 inch).
10 - - During assembly of linkage group on the machine, rotate the rod end of the bucket cylinder to position the grease fitting away from the stick.