SUPPORT AS 2369382 - Caterpillar

Illustration 1 g00287143
Location of Components
(1) Keypad. (2) Diagnostic service tool connector (ET). (3) 12 volt auxiliary connector.
Illustration 2 g01439132
Location of Components
(4) Diagnostic service tool connector (ET). (5) Starting/charging analyzer connector.
The diagnostic service tool connector has two locations. The first location is to the right of the operator's seat and the location is next to the keypad. The second location is on the left side of the machine at the rear corner of the body. The machine lockout is located on the same panel.
Illustration 3 g01439141
(6) Fuse Panel
The fuse panels are located to the right of the cab behind the electronics bay.
Illustration 4 g01439146
Location of Components (Right Side of the Cab)
(7) Junction block. (8) VIDS/VIMS Main Module. (9) VIDS/VIMS Interface Module 1. (10) VIDS/VIMS Interface Module 2. (11) Power train ECM. (12) Implement ECM.
The Electrical System Schematic, Parts Manual and Operation and Maintenance Manual for the machine that is being serviced should be used to locate electrical components and connectors.The following information is a guide to reading the tables on the back of the Electrical System Schematic.
The "Component Location" table uses white circles to mark the locations in the machine profile and in the area views. Alphabetical letters in the "Machine Location" column indicate a general area of the machine. Refer to the corresponding footnote at the end of the table for a description of the location.
The "Harness Connector Location" table uses white circles to mark the locations in the general view and in the area views. Alphabetical letters in the "Machine Location" column indicate a general area of the machine. Refer to the corresponding footnote at the end of the table for a description of the location.