SUPPORT 2390579 - Caterpillar

Illustration 39 g06164749
Language settings example
To select a new language, follow the procedure below:
Scroll up or down to find the new language.
Tap on the new language.To exit the language selection screen, tap the OS back button at the bottom of the screen (triangle left of center).Note: If a language selected does not support the language used by the display, the language will default to English.Sounds
Sounds allows the operator to adjust various display sound settings.
Sounds IconTo open the sounds screen, tap the "Sounds" button. The sounds button is situated to the right of the units icon, from the system settings menu.
Illustration 40 g06312599
(1) System buzzer volume slider
(2) Volume test play button
(3) Above-Grade on/off switch
(4) On-Grade on/off switch
(5) Below-Grade on/off switch
(6) Cancel button
(7) Done buttonSystem buzzer volume slider (1) - Raise and lower the system buzzer volume by tapping and holding the slider key and dragging it left (decrease volume) or right (increase volume).Volume test play button (2) - Tap to play a test sound to help judge the volume level.Above-Grade on/off switch (3) - Above-Grade on/off switch is used to turn the audible signal that indicates being Above Grade off (switch set to the left) or on (switch set to the right).On-Grade on/off switch (4) - On-Grade on/off switch is used to turn the audible signal that indicates being On Grade off (switch set to the left) or on (switch set to the right).Below-Grade on/off switch (5) - Below-Grade on/off switch is used to turn the audible signal that indicates being Below-Grade off (switch set to the left) or on (switch set to the right).Cancel button (6) - Cancel button is used to cancel changes.Done button (7) - Done button is used to accept changes.Display Brightness
Display brightness is used to adjust the overall brightness of the display screen. The display brightness control is part of the standard Android firmware.Display brightness control can be accessed by a swipe down motion from the top of the screen starting within the Android firmware notification bar. The notification bar is found above the display interface at the top of the screen (it will have a Wi-Fi connection icon in it on the right-hand side).Checking Bucket Wear
Attachments Screen
The bucket cutting edge will become worn over time, which will cause changes in the cutting edge measurements. The changes in the cutting edge measurements caused by bucket wear must regularly be checked as part of machine maintenance or as instructed by the site supervisor. Follow the below procedure to check the bucket wear length in either the machine monitor or the TD520 GRADE display:
Measure the cutting edge length to the bucket wear control point. The bucket wear control point was defined when the bucket was first measured up.Note: The bucket wear dimension, Current Length J-J1, can be modified only from the machine monitor.Note: If the bucket wears unevenly, use an average value. However, guidance will never be better than the range of the differences in cutting edge height.
To check the wear of the worktool from the TD520 GRADE display,