SUPPORT AS 2393450 - Caterpillar

General Information for Roading
Learn and obey all traffic regulations when you are roading the machine. Travel at a moderate speed. Observe all speed limitations when you road the machine. Ensure that the hydraulic system is locked out. Ensure that all work tools remain securely attached to the work tool coupler. Ensure that appropriate locking pins remain in position. Ensure that the machine meets all local requirements. Ensure that all roading decals are visible. Replace any decal that is damaged. Ensure that all necessary equipment for roading the machine is installed. The necessary equipment can be obtained from your local Caterpillar Dealer.Transport Lock Group (Bucket) (If Required)
Enter the machine. Fasten the seat belt. Start the engine.
Set the parking brake.
Raise the loader 305 mm (12 inch). Fully rack back the bucket.
Illustration 1 g01945819
Insert the lift arm brace (1) on the rod end of the lift cylinder. Insert the pin and secure the pin with the clip. Note: The flange on the brace must face the rear of the machine.Note: The lift arm brace is only used in Italian roading arrangements.
Install the strap (2) for the bucket onto the bracket on the loader lift arm.
Enter the machine. Fasten the seat belt. Turn the ignition key to the On position. Do not start the engine.
Slowly lower the lift arm onto the brace. Bucket Guard Group (If Required)
Illustration 2 g01945817Install the bucket guard over the cutting edge of the loader bucket. Secure the guard with the chains and clips.Transport Lock Group (Backhoe) (If Required)
Illustration 3 g01945816Install the transport lock between the bucket linkage and the stick. The transport lock prevents movement of the backhoe bucket.Reflective Plate (If Required)
Illustration 4 g01945815
Illustration 5 g01945813Mount a side reflective plate on both sides of the loader bucket. Mount the reflective plate on the backhoe bucket. Secure the plates in place with the thumb screws.Work Light Cover (If Required)
Illustration 6 g01945812
Turn off all of the work lights.
If required, cover all of the work lights before roading the machine. Backhoe Restraint (If Required)
Illustration 7 g01945811
Position the backhoe into the travelling position.
Position the strap around the base of the boom and around the bucket linkage.
Tighten the strap with the ratchet. Traffic Regulations
Learn and obey all of the traffic regulations when you are roading the machine.Leaving the Machine
Refer to Operation and Maintenance Manual, "Parking" for details about stopping the engine and lowering the equipment.The use of a wheel chock may be required when you leave the machine at the side of the road. The wheel chock is stored behind the steps on the right side of the machine.The use of warning triangles may be required when you leave the machine at the side of the road.Hydraulic Shutoff
Pilot Control
If equipped, disable the hydraulic controls. Refer to Operation and Maintenance Manual, "Operator Controls" for more information.Mechanical Control
Illustration 8 g01596189Insert the pin in order to disable the loader control.
Illustration 9 g01596278Insert the pin in order to disable the backhoe controls.