SUPPORT-DIODE 2414650 - Caterpillar

(1) Torque for the two bolts ... 100 20 N m (75 15 lb ft) (2) Tighten the 24 bolts to a torque of ... 210 30 N m (155 22 lb ft) and then turn an additional ... 120 10 degrees. (3) Tighten the 24 bolts to a torque of ... 130 30 N m (95 22 lb ft)and then turn an additional ... 120 10 degrees.(4) Tighten the 24 bolts to a torque of ... 210 30 N m (155 22 lb ft)and then turn an additional ... 120 10 degrees.
View A-A and View B-B(5) Torque for the four bolts ... 1800 200 N m (1330 150 lb ft)Procedure to Adjust the Differential Thrust Pin Perform this procedure only after the differential backlash and bearing adjustments have been completed.
Differential and Bevel Gear(1) Bolts.(6) Cover.(7) Shims.(8) Pin.1. Install the differential and bevel gear into the axle housing.2. Install pin (8) in the axle housing.3. Install cover (6) without the shims.4. Install bolts (1). Tighten the bolts enough to remove the end play between pin (8) and cover (6).5. Use a feeler gauge to measure the gap between the cover and the axle housing. Record this measurement. Use this measurement to determine the correct thickness of required shims.6. Install a thickness of shims that will establish a ... -0.03 mm (-0.001 inch)preload to a ... 0.03 mm (0.001 inch)end play in pin (8).7. Install cover (6) with the measured amount of shims (7).8. Install bolts (1). Tighten the bolts to a torque of ... 100 20 N m (75 15 lb ft).