SUPPORT AS 2444054 - Caterpillar

Winch Control Lever (If Equipped)
Free Spool (1) - The winch drum is disengaged from the drive train. This permits the cable to unwind freely. Hold (2) - The lever will stay in the HOLD position (2) when released. This will hold the load at the location selected. Reel In (3) - The winch will REEL IN the cable. The lever will return to the HOLD position (2) when released.
Adjust the drum drag and control the rate of descent of the load to prevent the cable from balling up on the winch drum when the load is lowered to the ground.
If the winch will not reel in or the winch pinion brake will not hold the load, see the section Operating Adjustments in this manual.Dozer Blade Control Lever
LOWER (1) - Push the lever forward from the HOLD position to lower the dozer blade. The lever will return to HOLD when released. HOLD (2) - The lever will return to HOLD when it is released from either the RAISE or the LOWER position. Dozer blade will remain in the position it is in, when the lever is released. RAISE (3) - Pull the lever back to raise the dozer blade. Release the lever to stop raising the dozer blade. The lever will return to HOLD when released.Grapple Control Levers (If Equipped)
RAISE (1) - Move lever to position (1) to raise the grapple. HOLD (2) - Move lever to position (2) to stop the grapple movement. LOWER (3) - Move lever to position (3) to lower the grapple. CLOSE (1) - Move lever to position (1) to close the grapple. HOLD (2) - Move lever to position (2) to stop grapple movement. OPEN (3) - Move lever to position (3) to open the grapple.Grapple Rotation
Grapple rotation is as viewed from operator seat looking forward. Grapple left (1) - Move lever to position (1) to rotate the grapple counterclockwise. Grapple hold (2) - Move lever to position (2) to stop grapple movement. Grapple right (3) - Move lever to position (3) to rotate the grapple clockwise.