parts catalog

SUPPORT AS 2559863 - Caterpillar

2559863 SUPPORT AS Caterpillar parts SUPPORT
Alternative (cross code) number:
Caterpillar 2559863 SUPPORT AS

Buy SUPPORT AS 2559863 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Burn Prevention
At operating temperature, the engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot water or steam. Any contact can cause severe burns. Check the coolant level only after the engine has been stopped and the filler cap is cool enough to remove with your bare hand.Remove the cooling system filler cap slowly to relieve pressure.Cooling system conditioner contains alkali that can cause personal injury. Avoid contact with the skin and eyes and do not drink.Allow cooling system components to cool before draining.Hot oil and components can cause personal injury. Do not allow hot oil or components to contact the skin.At operating temperature, the hydraulic tank is hot and can be under pressure. Remove the hydraulic tank filler cap only after the engine has been stopped and the filler cap is cool enough to remove with your bare hand.Remove the hydraulic tank filler cap slowly to relieve pressure.Relieve all pressure in air, oil, fuel or cooling systems before any lines, fittings or related items are disconnected or removed. Battery electrolyte contains acid that can cause injury. Avoid contact with the skin and eyes.Fire or Explosion Prevention
All fuels, most lubricants and some coolant mixtures are flammable.Do not smoke while refueling or in a refueling area.Do not smoke in areas where batteries are charged, or where flammable materials are stored.Batteries in series may be located in separate compartments. When using jumper cables always connect positive (+) cable to positive (+) terminal of battery connected to starter solenoid and negative (-) cable from external source to starter negative (-) terminal. (If not equipped with starter negative terminal, connect to engine block.)See the "Operation Section" of this guide for specific instructions.Clean and tighten all electrical connections. Check daily for loose or frayed electrical wires. Have all loose or frayed electrical wires tightened, repaired or replaced before operating the machine.Keep all fuels and lubricants stored in properly marked containers and away from all unauthorized persons.Store all oily rags or other flammable material in a protective container, in a safe place.Do not weld or flame cut or pipes or tubes that contain flammable fluids. Clean them thoroughly with nonflammable solvent before welding or flame cutting on them.Remove all flammable materials such as fuel, oil and other debris before they accumulate on the machine.Do not expose the machine to flames, burning brush, etc., if at all possible.Shields, which protect hot exhaust components from oil or fuel spray in the event of a line, tube or seal failure, must be installed correctly.Ether is flammable. Do not smoke while changing ether cylinders.Use ether only in well ventilated areas.Keep ether cylinders out of the reach of unauthorized persons.Do not store replacement ether cylinders in living areas or in the operator's compartment.Do not store ether cylinders in direct sunlight. Discard cylinders in a safe place. Do not puncture or burn cylinders.Lines, Tubes and Hoses
Do not bend or strike high pressure lines. Do not install bent or damaged lines, tubes

Parts support Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.