SUPPORT AS 2642006 - Caterpillar

Illustration 1 g00902443
Top View (1) Refer to Specifications, "Solenoid Valve (Transmission Upshift/Downshift)". Final installation torque for three valves (1) ... 50 5 N m (37 4 lb ft) (2) Torque for the four bolts that are marked with an "X" ... 48 4 N m (35 3 lb ft) (3) Torque for five bolts ... 30 4 N m (22 3 lb ft) (4) Torque for bolt ... 48 4 N m (35 3 lb ft)
Illustration 2 g00902444
View B-B
Do not use any caustic (corrosive) materials in order to clean any parts of this group. Caustic materials will cause corrosion and damage to the parts.
(5) Torque for two bolts ... 48 4 N m (35 3 lb ft) (6) Lubricate the sealing lip with a small amount of the lubricant that is being sealed.Before you install the lip seal, put a coat of 7M-7260 Liquid Gasket on the sealing bore. Allow the liquid gasket to dry before you install the seal. Do not put any liquid gasket on the lip seal. Install the seal so that the seal lip faces the inside of the component. (7) Torque for two bolts ... 48 4 N m (35 3 lb ft) (8) The notch on the connector for the wiring harness should face upward. The centerline of the notch on the connector should be parallel with the mounting face of the switch. (9) Refer to Specifications, "Lubrication Relief Valve (Transmission)". Installation torque ... 41 7 N m (30 5 lb ft)
Illustration 3 g00902460
View A-A (10) Refer to Specifications, "Pressure Control Valve (Transmission)". (11) Torque for bolt ... 30 4 N m (22 3 lb ft) (12) Torque for 12 bolts ... 30 4 N m (22 3 lb ft) (13) Refer to Specifications, "Selector and Pressure Control Valve (Transmission)". (14) Torque for two bolts ... 30 4 N m (22 3 lb ft) (15) Refer to Specifications, "Rotary Actuator (Transmission)". (16) Torque for bolt ... 30 4 N m (22 3 lb ft)