SUPPORT 2G1699 - Caterpillar

Illustration 1 g01004303
Winflash Screen
Click on the "Browse" button. Locate the flash file 232-9737.FLS.
Click on the "Begin Flash" button in order to install the flash file.
Click on the "Cat ET" button at the completion of the flash process.
Illustration 2 g01004007
Click on the "Cat ET" button at the completion of the flash process.Setting Time Zone, Date, and Time
Note: The information contained in this section is new and therefore is not included in the current Machine Security System Service Manual (RENR2462-04). Add this information to your copy of the MSS Service Manual.Note: Changing the MSS clock requires a key (with master access level) or a factory password. When using a key with master access level, you must ensure that the MSS is not in the 30 second grace period before inserting the key. To determine if MSS is in the 30 second grace period, view the MSS Status LED. When the 30 second grace period is active, the MSS Status LED will be illuminated GREEN with the keyswitch in the OFF position.Procedure
Connect a PC (with Caterpillar ET) to the machine via the communication adapter.
Place a key (with the master access level) in the key start switch.
Turn the key switch to the ON position.
Start ET. Establish communications with the MSS ECM.
Select the "ECM date/time" option from the "Service" menu. This will cause ET to display the screen shown in Illustration 3.Note: In most instances, the time zone information will not be correct.
Illustration 3 g01004010
ECM Date/Time Screen
Click on the "Change" button. This will cause ET to display the "Date and Time" dialog box.
Illustration 4 g01004012
"Date and Time" dialog box
Select your local time zone from the drop-down list. If necessary, set the correct date. Set the correct local time. Click the "OK" button.
Press the "F5" key in order to view the ET Configuration Screen. Verify that the Bypass Schedule times are correct.
STOP. This completes the update procedure.
Illustration 5 g01004013
ET Configuration ScreenPreserving the Key List and Bypass Schedule
Turn the disconnect switch to the ON position.
Connect the Communications Adapter between the machine and the PC.
Using a key with master access level, turn the keyswitch to the ON position. Verify that the MSS Status LED is green.
Start ET and allow ET to connect with the CAT Data Link. If ET detects more that one ECM, select the ECM for Machine Security System.
To load the data from the ECM, perform the following steps:
From the menu bar, select "Service".
From the "Service" menu, select "Copy Configuration".
From the "Copy Configuration" menu, select "Fleet Key Configuration". If there is no recently loaded data available, the "No data is available..." message box will be displayed.
Click the "Yes" button to load the data from the ECM. The "ECM Selector" dialog box will be displayed.
If prompted, highlight the Machine Security System ECM and click on "OK". As the data is loading from the ECM, the "Please wait." message will be displayed. Next, the "Loading data from ECM." progress bar will be displayed.
When the data has been successfully loaded into the ECM, the "The data has been successfully loaded." message will