SUPPORT A.-RH 2L3611 - Caterpillar

Illustration 15 g06146883
Area "D", inside swing compartment
(4) Cable Straps
(12) Hose Assembly
(14) Hose Assembly
Route hose assembly (12) and hose assembly (14) as illustrated above. The 45-degree fitting on hose assembly (12) must be toward the front of the machine.
Install three cable straps (4) as illustrated above. Leave the cable straps loose to allow movement of the hoses.
Illustration 16 g06146891
Area "C", inside swing compartment
(12) Hose Assembly
(14) Hose Assembly
(16) Tee
(31) Tee
Connect the 45-degree fitting on hose assembly (12) to Tee (31) as illustrated above.
Connect hose assembly (14) to Tee (16) as illustrated above.
Remove the slack from the hose routing, and tighten three cable straps (4).Note: Refer to Step 21 for location of the cable straps.
Illustration 17 g06146895
Under rear of machine
(N) Cover plate
Remove bottom cover plate (N).
Illustration 18 g06146897
Area "E", under rear of machine
(4) Cable Straps
(12) Hose Assembly
(14) Hose Assembly
Route hose assembly (12) and hose assembly (14) as illustrated above.
Install two cable straps (4) as illustrated above.
Illustration 19 g06146898
Area "G", under rear of machine
(12) Hose Assembly
(P) Pilot Valve Assembly
Route hose assembly (12) to port "PSA2" of pilot valve assembly (P) as illustrated above.
Illustration 20 g06146786
Under rear of machine
(R) Connector
(S) Hose Assembly
Disconnect hose assembly (S) from connector (R). Remove the connector from the pilot manifold.
Illustration 21 g06146900
Under rear of machine
(12) Hose Assembly
(19) O-Ring Seal
(22) O-Ring Seals
(26) Tee
(S) Hose Assembly
Install O-ring seal (19) and two O-ring seals (22) on Tee (26), and install the Tee as illustrated above.
Connect hose assembly (12) to Tee (26) as illustrated above.
Connect hose assembly (S) to Tee (26) as illustrated above.
Illustration 22 g06146901
Under rear of machine
(14) Hose Assembly
Route hose assembly (14) into the pump compartment as illustrated above.
Illustration 23 g06146903
Right side of machine
(T) Pump Compartment Door
Open pump compartment door (T). Install the door prop.
Illustration 24 g06146904
Area "F", front of pump compartment
(14) Hose Assembly
(U) Hose Assembly
Route hose assembly (14) as illustrated above.
Disconnect hose assembly (U).
Illustration 25 g06146906
Front of pump compartment
(14) Hose Assembly
(19) O-Ring Seal
(22) O-Ring Seal
(26) Tee
(29) Adapter
(U) Hose Assembly
Install O-ring seal (19) on adapter (29), and install the adapter as illustrated above.
Install O-ring seal (19) and two O-ring seals (22) on Tee (26), and connect the Tee to adapter (29) as illustrated above.
Connect hose assembly (14) to Tee (26) as illustrated above.
Connect hose assembly (U) to Tee (26) as illustrated above.
Illustration 26 g00687600
Check for leaks.
Close pump compartment door (T).
Replace bottom cover (N).
Replace rubber sheet (A).
Replace enclosure arrangement (B).