SUPPORT GROUP 2P7757 - Caterpillar

Nomenclature
The 362-4250 Tool Kit consists of the following components.
Table 1
Part Number     Quantity     Description    
362-4250     1     Deck Height Measuring Tool    
362-4251 (1)     1     Tube 38.078 0.008 mm (1.49913 0.00031 inch) DIAMETER    
362-4252 (1)     1     Plate Kit    
362-4253     1     Gauge Kit    
( 1 ) Part of the 362-4250 Tool Kit Setup Section
Assembly of 362-4253 Gauge Kit
Illustration 3 g02151676
Depress one of the lock screws (1) and turn the lock screw clockwise. Turn lock screw (1) clockwise until the T shaped end of the lock screw can be inserted into the corresponding T shaped slot of bar (2) .
Illustration 4 g02151677
Fully retract the foot (4) of the depth gauge and slide bar (2) towards the second lock screw (3). Turn the lock screw (3) clockwise until the T shaped end of the lock screw can be inserted into the corresponding T shaped slot of bar (2) .
Illustration 5 g02152124
Center bar (2) with the depth gauge and turn locking screws (1) and (3) counterclockwise. This will lock bar (2) in position and hold the bar firmly against the depth gauge.Note: Operators depth micrometer may be different than shown. Please refer to the manual that is provided with operators depth micrometer.Setup of 362-4252 Plate Kit and 362-4251 Tube
Note: The bar should be stored in a protective cover, such as a piece of PVC pipe. One end of the PVC pipe should have a glued on cap and the other end of the PVC pipe should have a removable cap. The PVC pipe can also be left on the bar when you are sliding the bar through the engine block to prevent nicks and other damage to the bar or the crankshaft bore journals.
Illustration 6 g02160058
(1) Glued end cap (2) PVC pipe (3) Tube (4) Plate Kit (5) Bolt and Washer (dealer supplied)
Illustration 7 g02154243
Slide the bar (3) out of the PVC pipe (2) enough so that you can install the proper end plate (4). Secure the proper end plate (4) onto the bar with the bolt and washer (5). Slide the bar with the PVC pipe still attached through the engine block. You will need to use a second person to aid in the installation of the bar through the engine block.Note: Each of the end plates will be marked "FRONT" or "REAR". The end plates will also be marked "TOP". Make sure that the correct end plate is used on the proper side of the engine and each end plate is oriented correctly.
Position the end plate over the dowels on the end of the engine block. The end plates fit snug over the dowels but the end plates can be installed by hand.
Illustration 8 g02154251
Remove the PVC pipe and install the other end plate onto the engine. Install the other bolt and washer (4). Tighten the bolt hand tight.
Tool is now ready to take measurement refer to Reuse And Salvage Guidelines, SEBF9213-00Maintenance Section
Inspection
Inspect prior to each