SUPPORT AS-FRONT 2V6327 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-1860 Retaining Ring Pliers 1 Start By:
Remove the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install" for the correct procedure.
Remove the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove" for the correct procedure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Use a deep socket in order to remove the electrical connections from the electronic unit injectors. Use of incorrect tooling will result in damage to the electronic unit injectors.
Illustration 1 g01355167
Typical example
Make a temporary identification mark on connections (1).
Use a deep socket to remove connections (1) from electronic unit injectors (2).
Disconnect plugs (7) from harness assemblies (4).
If necessary, follow Step 4.a through Step 4.e in order to remove harness assemblies (4) from valve mechanism cover base (6).
Cut cable strap (3).
Use Tooling (A) to remove circlip (5).
From the outside of valve mechanism cover base (6), push harness assembly (4) inward. Withdraw the harness assembly from valve mechanism cover base (6).
Remove O-ring seal (8) from harness assembly (4).
Repeat Step 4.a through Step 4.d in order to remove the remaining harness assembly.
Illustration 2 g01354234
Typical example
Illustration 3 g01354235
Tightening sequence for the valve mechanism cover base
Gradually loosen the captive bolts that secure the valve mechanism cover base in reverse numerical order. Refer to Illustration 3. Gradually loosen the captive bolts will help prevent distortion of the valve mechanism cover base. Note: The captive bolts cannot be removed from the valve mechanism cover base.
Remove valve mechanism cover base (6) from the cylinder head.
Remove seal (9) from valve mechanism cover base (6). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 1P-1860 Retaining Ring Pliers 1
B 1U-6396 O-Ring Assembly Compound 1
C 247-5377 Torque Wrench 1
D 321-5184 Alignment Pins 2
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Use a deep socket in order to remove the electrical connections from the electronic unit injectors. Use of incorrect tooling will result in damage to the electronic unit injectors.
Clean the valve mechanism cover base. Ensure that the mating surfaces are free from damage.
Illustration 4 g01354234
Typical example
Install seal (9) to valve mechanism cover base (6). Ensure that the seal is seated correctly in the groove in the valve mechanism cover base.
Illustration 5 g01354235
Tightening sequence for the valve mechanism cover base