SUPPORT AS 3004929 - Caterpillar

Assembly Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01735156
Install backup ring (37), O-ring seal (36), and O-ring seal (35).
Illustration 2 g01735155
Install relief valve (34). Tighten relief valve (34) to a torque of 35 2 N m (26 1 lb ft).
Illustration 3 g01735153
Install ring (33), O-ring seal (32), ring (31), ring (30), O-ring seal (29), ring (28), and O-ring seal (27).
Illustration 4 g01735133
Install nipple (26). Install dust cover (25). Install solenoid valve (24). Tighten solenoid valve (24) to a torque of 24 3 N m (212 27 lb in).
Illustration 5 g01735117
Install plug (20). Install coil assembly (22). Install nut (21). Tighten nut (21) to a torque of 5 2 N m (47 13 lb in).
Illustration 6 g01735098
Install plug (19).
Illustration 7 g01735096
Install ring (18), O-ring seal (17), ring (16), and O-ring seal (15).
Illustration 8 g01735095
Install orifice (14). Install plug (13). Install plug (12). Install plug (11).
Illustration 9 g01735094
Install ring (10), O-ring seal (9), ring (8), ring (7), O-ring seal (6), ring (5), and O-ring seal (4).
Illustration 10 g01735076
Install control valve (3). Tighten control valve (3) to a torque of 86 9 N m (64 6 lb ft). Install plug (2). Install plug (1). End By:
Install the flow control and relief valve (rear axle oil). Refer to Disassembly and Assembly, "Flow Control and Relief Valve (Rear Axle Oil) - Install".