SUPPORT GP-RADIATOR 3031539 - Caterpillar

Table 1
Required Tools    
Description    Qty    
Measuring Tape     1    
Stopwatch     1    
Illustration 1 g00924510
(A) Preliminary run 5 m (16.4 ft) (B) Travel distance 20 m (65.6 ft) (C) Height of grapple 0.5 to 1 m (1.6 to 3.3 ft)
Travel distance must be at least 25 m (82 ft) long. Travel test ground must be hard and as level as possible.
Draw a 25 m (82 ft) straight line on travel test ground as a reference line.
Start the engine.
Place the machine controls at the following settings: Engine speed dial "10" and AEC switch OFF.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F).
Position the machine so that one track is parallel with the reference line. Position the machine for the travel test. Refer to Illustration 1.
Place the travel speed control switch in HIGH position.
Move the machine by operating both travel levers at the same time.
The first 5 m (16.4 ft) are for a preliminary run. Measure the travel time that is required to travel the remaining 20 m (65.6 ft). Measure the time that is required in each direction.
Measure the travel deviation from the reference line.
Place the travel speed control switch on the LOW position and repeat Steps 8 through 10.
Table 2
Travel Time (time in seconds)    
Travel Speed    New    Rebuild    Service Limit    
HIGH     Forward     17 or less     19.0 or less     22.5 or less    
Reverse
LOW     Forward     20.8 or less     26.0 or less     29.5 or less    
Reverse Note: The following table represents the travel deviation (distance) from the reference line.
Table 3
Travel Deviation
mm (inch)
   
Travel Speed    New    Rebuild    Service Limit    
HIGH     Forward     800 (31.5) or less     1200 (47.2) or less     1500 (59.1)    
Reverse
LOW     Forward     800 (31.5) or less     1200 (47.2) or less     1500 (59.1)    
Reverse