SUPPORT-ENGINE 3295023 - Caterpillar

Illustration 18 g03284996
Remove bracket assembly (28).
Remove bolts (29). Remove cover (30) and the O-ring seal.
Illustration 19 g03286418
Remove bolts (31) and sensor assembly (32).
Repeat Steps 21 and 22 for remaining cover assembly.
Illustration 20 g03288316
Install Tooling (B) and a suitable lifting device to housing assembly (33). The weight of housing assembly (33) is approximately 113 kg (250 lb).
Remove bolts (34). Remove housing assembly (33) and the O-ring seal.
Illustration 21 g03289358
Under side of flange
Remove retaining ring (35). Remove case (36) and the O-ring seal.
Remove lip seal (37).
Illustration 22 g03289758
Remove retaining rings (38) and gears (39).
Illustration 23 g03289876
Remove retaining rings (40).
Illustration 24 g03290297
Illustration 25 g03290456
Remove shaft assembly (42) and dowel (41). Note: Dowel will unseat when removing shaft assembly.
Repeat Step 30 for remaining shaft assembly.
Illustration 26 g03292218
Use a suitable press to remove bearing assembly (43).
Illustration 27 g03292396
Remove retaning ring (44).
Illustration 28 g03292478
Use Tooling (D) and a suitable press to remove bearing assembly (45).
Repeat Steps 32 through 34 for remaining shaft.
Illustration 29 g03292739
Remove swash plate (46).
Illustration 30 g03294516
Remove bolts (47), the washers, and the spacers. Remove magnet (48).
Remove bolts (50) and block arm (49).
Illustration 31 g03294681
Remove bearings (51).
Repeat Steps 36 through 39 for remaining swash plate.
Illustration 32 g03294657
Remove bearings and timing links (52).
Illustration 33 g03294740
Remove races (53).