SUPPORT AS 3330497 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     365 997.0     Link Bracket     2    
Illustration 1 g00625868
Fasten Tooling (A) and a hoist to power take-off (17), as shown. Position power take-off (17) on the machine. Install four bolts (18) and the washers that hold the power take-off in position. The weight of the power take-off is 150 kg (330 lb).
Illustration 2 g00625819
Connect power take-off drive shaft (16) to the power take-off by using four bolts (15) and the four washers. Tighten bolts (15) to a torque of 135 15 N m (100 11 lb ft).
Illustration 3 g00625664
Illustration 4 g00625781
Install guard (10) over the power take-off shaft.
Install hose assembly (5) on guard (10) with clip (14) and bolt (13) .
Install support (12) and support (9) with bolts (11) and the washers.
Install support (12) and support (9) to the power take-off with bolts (8) .
Illustration 5 g00625771
Install bolt (6) and the washer in clip (7) in order to secure the hose.
Illustration 6 g00625763
Connect hose assembly (5) to the power take-off.
Illustration 7 g00621365
Tighten four clamps (4) .
Make sure that plug (3) is installed in the power take-off.
Fill the power take-off and final drive with oil to the correct level. The capacity of the final drive and power take-off is approximately209 L (55 US gal). Refer to Operation and Maintenance Manual, "Differential and Final Drive Oil and Screens - change/clean" for the proper filling procedure.
Illustration 8 g00621359
Install guard (2) by using four bolts and washers (1) .End By:
Install the drawbar and support. Refer to Disassembly and Assembly, "Drawbar and Support - Remove and Install" for the machine that is being serviced.
Install the three-point hitch. Refer to Disassembly and Assembly, "Three-Point Hitch - Install" for the machine that is being serviced.