SUPPORT 3370981 - Caterpillar

Illustration 1 g03493018
Typical example
Table 1
Specification for 363-1054 Hoe Stick Gp and 363-1059 Hoe Stick Gp
Item Qty Part Specification Description
- All the bores must be free of paint. Use 5P-0960 Grease Cartridge in order to coat all the bores for the pins, the bucket, and the cylinder pin bores.
1 The stick cylinder must be assembled in order to orient the grease zerk, as shown in Illustration 1.
2 1 308-8938 Pin As Diameter is 109.85 0.04 mm (4.325 0.002 inch).
3 1 367-1436 Pin As Diameter is 129.85 0.04 mm (5.112 0.002 inch).
4 2 166-1495 Lip Type Seal Lubricate the sealing lip of the lip type seals lightly with the lubricant that is being sealed.
Install the dust seal so that the lip faces outside, as shown.
Install the lip type seals so that the lip type seals do not extend beyond the face of the boss.
5 2 9X-4599 Lip Type Seal Lubricate the sealing lip of the lip type seals lightly with the lubricant that is being sealed.
Install the dust seal so that the lip faces outside, as shown.
Install the lip type seals so that the lip type seals do not extend beyond the face of the boss.
6 2 234-3749 Bushing(1) Bore before assembly is 130.36 0.04 mm (5.132 0.002 inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
7 2 9X-4600 Lip Type Seal Lubricate the sealing lip of the lip type seals lightly with the lubricant that is being sealed.
Install the dust seal so that the lip faces outside, as shown.
Install the lip type seals so that the lip type seals do not extend beyond the face of the boss.
8 As required, use the following shims to adjust the maximum lateral clearance to 1.0 mm (0.04 inch):
1 133-2428 Shim Thickness is 0.5 mm (0.02 inch).
2 4I-0575 Shim Thickness is 1.0 mm (0.04 inch).
1 4I-0577 Shim Thickness is 2.0 mm (0.08 inch).
9 As required, use the following shims to adjust the maximum lateral clearance to 1.0 mm (0.04 inch):
1 151-0653 Shim Thickness is 0.5 mm (0.02 inch).
2 093-0076 Shim Thickness is 1.0 mm (0.04 inch).
1 093-0108 Shim Thickness is 2.0 mm (0.08 inch).
10 2 7Y-2396 Bushing(1) Bore before assembly is 90.27 0.02 mm (3.6 0.001 inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
11 2 228-5621 Bushing(1) Bore before assembly is 120.32 0.04 mm (4.737 0.002 inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
(1) Install the bushing in the bore so that the part number of the bushing is facing outward.