SUPPORT AS 3572616 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1U-5230     Hand Hydraulic Pump     1    
B     155-3597     Wheel Chock     4    Start By:
Connect the steering frame lock.
Release the hydraulic system pressure.Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Chock the wheels of the machine with Tooling (B) .
Illustration 1 g01169584
Disconnect hose assembly (1) from parking brake actuator (2) .
Illustration 2 g01169585
Install Tooling (A) onto parking brake actuator (2). Use Tooling (A) to release the tension on the reaction arm of the parking brake.
Illustration 3 g01169587
Remove pin (4) and nuts (3) .
Release the pressure on Tooling (A) and remove Tooling (A) .
Remove parking brake actuator (2) .Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1U-5230     Hand Hydraulic Pump     1    
B     155-3597     Wheel Chock     4    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 4 g01169585
Illustration 5 g01169587
Position parking brake actuator (2) and install nuts (3) .
Install Tooling (A) onto parking brake actuator (2) .
Use Tooling (A) to extend the yoke of parking brake actuator (2) and install pin (4) .
Remove Tooling (A) .
Illustration 6 g01169584
Install hose assembly (1) onto parking brake actuator (2) .
Remove Tooling (B) .End By: Separate the steering frame lock.