3C8066 SUPPORT Caterpillar parts
Rating:
Alternative (cross code) number:
CA3C8066
3C-8066
3C8066
CA3C8066
3C-8066
3C8066
Weight: 5 pounds 2 kg.
For full view, you need register
Information:
Starting With the Starting Aid Switch (If Equipped)
Personal injury or property damage can result from alcohol or starting fluids.Alcohol or starting fluids are highly flammable and toxic and if improperly stored could result in injury or property damage.
Excessive starting fluid can cause piston and ring damage.Use starting fluid for cold starting purposes only.Do not use excessive starting fluid during starting or after the engine is running.
The optional ether starting aid which is located on the control panel is the only system that is recommended for the injection of starting fluid.
Perform the procedures that are described in this Operation and Maintenance Manual, "Before Starting Engine".
Press the "RUN" key.
Ether will automatically be injected if the following conditions are met:
The Starting Aid switch is in the AUTOMATIC position.
The jacket water coolant temperature is less than 0 °C (32 °F).
Additional injections may be necessary in order to start the engine. Additional injections may also be necessary in order to achieve low idle. If additional injections are necessary, toggle the Starting Aid switch to the MANUAL position. For additional injections, the jacket water coolant temperature must be less than 10 °C (50 °F). Note: The Starting Aid switch is a momentary switch. To stop the injection, release the Starting Aid switch.
Personal injury or property damage can result from alcohol or starting fluids.Alcohol or starting fluids are highly flammable and toxic and if improperly stored could result in injury or property damage.
Excessive starting fluid can cause piston and ring damage.Use starting fluid for cold starting purposes only.Do not use excessive starting fluid during starting or after the engine is running.
The optional ether starting aid which is located on the control panel is the only system that is recommended for the injection of starting fluid.
Perform the procedures that are described in this Operation and Maintenance Manual, "Before Starting Engine".
Press the "RUN" key.
Ether will automatically be injected if the following conditions are met:
The Starting Aid switch is in the AUTOMATIC position.
The jacket water coolant temperature is less than 0 °C (32 °F).
Additional injections may be necessary in order to start the engine. Additional injections may also be necessary in order to achieve low idle. If additional injections are necessary, toggle the Starting Aid switch to the MANUAL position. For additional injections, the jacket water coolant temperature must be less than 10 °C (50 °F). Note: The Starting Aid switch is a momentary switch. To stop the injection, release the Starting Aid switch.