SUPPORT AS 4219085 - Caterpillar

Connection Procedure
Table 1
Required Tools
Tool Part Number Description Qty
A FT-2213 Strap (Group) 1
8S-4755 Bolt (1 inch by 14 by 1 1/2 inch) 4
6B-9194 Bolt (1 inch by 14 by 3 inch) 2
3K-5234 Washer (6 mm by 49 mm) 18 Reference: Refer to Specifications, SENR8324, "Tracks" in the Service Manual for your machine.
Illustration 1 g00617969
Place the track under the machine.
Lower the machine on the track.
Remove tool (A).
Illustration 2 g00619611
Attach a chain to a wheel loader or a similar machine and to the end of track (8). Pull track (8) over the front idler.
Illustration 3 g00619609
Lift the end of the track in order to position wood blocks (9) under the grouser. See Illustration 3.
Pull the track until the bushings engage the sprocket segments on the final drive.
Start the machine and rotate the final drive backward in order to pull the track together.
Illustration 4 g00617971
Align the lower end of master link (7) with the upper end of the master link.
Illustration 5 g00617972
Position the master shoe (6) on the master link.
Apply 4C-5593 Thread Compound to bolts (5).
Install bolts (5).
Tighten bolts (5) to a torque of 650 70 N m (480 50 lb ft). Tighten the bolts by 1/3 turn more.
Illustration 6 g00617973
Tighten relief valve (2) and fill valve (3) to a torque of 34 7 N m (25 5 lb ft).
Illustration 7 g00619722
Typical Example
Use the following procedure to adjust the track:
Move the machine forward for a distance that is two times the length of the machine. Allow the machine to come to a stop without the use of the brakes.
Position a tight line on the grouser tips at the sprocket and the front idler.
Measure dimension (X) from the line to the lowest grouser tip. Fill the track adjuster with 5P-0960 Molybdenum Grease until dimension (X) is 115 10 mm (4.5 0.4 inch).
Do not tighten the track if dimension (Y) is greater than 142 mm (5.6 inch). If dimension (Y) is greater than 142 mm (5.6 inch), the track must be removed and reconditioned.
Illustration 8 g00617976
Install the track adjuster cover and the O-ring seal on the track roller frame.