SUPPORT AS 4645601 - Caterpillar

Select "Configuration" from the "Service"menu.
Illustration 26 g06246654
Expand the list for "Control Input Installations and Configurations". Highlight the parameter to change and click the "Change" button on the lower left corner.
Illustration 27 g06246658
Select the appropriate "Control Input" for the controls installed on the machine. Press OK to enter the change.Reference: Refer to "Control Installation Parameter Descriptions" for descriptions of each of the Tool Installation parameters that are available for the tool control system.Control Installation Parameter Descriptions
Table 4
Control Installation Parameter Descriptions
Cat ET Name Monitor Name Description Explanation
Joystick Handle Configuration "Joystick Handle" Type of joystick handle Set type of joystick handle installed on the machine.
Type of handle:
"Basic Handle": Lever installed on the standard machine
"Joystick Switch": Lever with 4 buttons on standard lever
"Modulation Handle": Lever with thumb wheel and 3 buttons
Left Attachment Pedal Installation Status "Left Attachment Pedal" Installation setting of left ATT pedal Set installation condition of left ATT pedal.
Right Attachment Pedal Installation Status "Right Attachment Pedal" Installation setting of right ATT pedal Set installation condition of right ATT pedal.
Left Joystick Switch #2 Control Mode "Left Joystick Switch #2" Operating target of left joystick switch #2 Set ATT valve and switching operation to be operated by left joystick switch #2.
"Momentary" is selected to press and hold the switch for tool activation.
"Toggled" is selected to press for tool activation ON and press again for tool activation OFF.
If the handle type is "Basic Handle", then setting is not required.
Left Joystick Switch #3 Control Mode "Left Joystick Switch #3" Operating target of left joystick switch #3 Set ATT valve and switching operation to be operated by left joystick switch #3.
"Momentary" is selected to press and hold the switch for tool activation.
"Toggled" is selected to press for tool activation ON and press again for tool activation OFF.
If the handle type is "Basic Handle", then setting is not required.
Left Joystick Switch #4 Control Mode "Left Joystick Switch #4" Operating target of left joystick switch #4 Set ATT valve and switching operation to be operated by left joystick switch #4.
"Momentary" is selected to press and hold the switch for tool activation.
"Toggled" is selected to press for tool activation ON and press again for tool activation OFF.
Handle is limited to "Joystick Switch" alone.
Right Joystick Switch #1