SUPPORT GP-ENGINE 4P5817 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     124-2946     Lifting Bracket     1    Start By:
Remove the variable valve actuator.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g03857624
Valve rocker arms and unit injector rocker arms can move on the shaft after the bolts have been removed. The shaft should be kept level when removed from the cylinder head. To avoid possible personal injury, keep fingers clear of the valve rocker arms and the unit injector rocker arms when lifting the assembly from the cylinder head.
Remove bolts (2) .
Use Tooling (A) to remove rocker arm shaft assembly (4) , valve rocker arms (3) , and electronic unit injector rocker arms (1) as a unit.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g03857616
Illustration 3 g03857618
Valve rocker arms and unit injector rocker arms can move on the shaft after the bolts have been removed. The shaft should be kept level when removed from the cylinder head. To avoid possible personal injury, keep fingers clear of the valve rocker arms and the unit injector rocker arms when lifting the assembly from the cylinder head.
Position rocker arm shaft assembly (4) , valve rocker arms (3) , and electronic unit injector rocker arms (1) as a unit with Tooling (A) on the cylinder head.Note: Apply clean engine oil to the underside of the bolt heads prior to installation.
Install bolts (2) and tighten in the following sequence: 2, 3, 1, 4 to a torque of 55 5 N m (41 4 lb ft). Tighten bolts (2) in the same sequence again to a torque of 55 5 N m (41 4 lb ft). Turn bolts (2) in the same sequence for an additional 60 5 degrees.
Adjust the electronic unit injectors. Refer to Testing and Adjusting, "Electronic Unit Injector - Adjust".
Adjust the engine valve lash. Refer to Testing and Adjusting, "Engine Valve Lash - Inspect/Adjust".End By: Install the variable valve actuator.