SUPPORT AS 4V6429 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00554514
Typical Example
Disconnect the sending unit (4) from the cover.
Remove the bolts that hold the cover (2) to the oil temperature regulator housing (1).
Remove the cover (2) and the tube (3).
Illustration 2 g00554516Note: It is not necessary to remove the oil temperature regulator housing (1) from the engine in order to remove the oil temperature regulators (5).
Remove the gasket and oil temperature regulators (5) from the oil temperature regulator housing (1).
Remove the lip type seals from the oil temperature regulator housing (1). Installation Procedure
Table 1
Required Tool
Tool Part Number Part Description Qty
A 1P-0510 Driver Group 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Use Tool (A) in order to install the lip type seals in the oil temperature regulator housing (1) with the lip of the seal away from the cover (2).
Install the oil temperature regulators (5) in the oil temperature regulator housing (1).
Install new O-ring seals on the tube (3). Put clean engine oil on the O-ring seals.
Place the tube (3), the cover (2), and the gasket in position on the oil temperature regulator housing (1). Install the bolts that hold the tube (3), the cover (2), and the gasket in position.
Connect the sending unit (4) to the cover.
Ensure that the oil level of the engine is filled to the proper level. Refer to the Operation And Maintenance Manual for additional information.