SUPPORT 5292170 - Caterpillar

Illustration 1 g01161338
The location of the rotor mode control (1) and the rotor elevation control (2) .The rotor mode control (1) is a three-position switch. The rotor elevation control (2) is a two-position switch. The rotor mode control and the rotor elevation control are located on the operator side console.
Illustration 2 g01161345
The three positions of the rotor mode control
Illustration 3 g01208143
The location of the rotor depth setpoint control (6) and the display panel (7) .The rotor depth setpoint control (6) is a two-position momentary switch. The rotor depth setpoint control is located on the operator console.TRAVEL MODE (3) - This mode will move the rotor to a height that is suitable for travel of the machine. This mode allows the operator to go over obstructions. This mode allows the operator to travel between cuts. Move the rotor mode control to the TRAVEL position for engagement of the rotor service lock.MANUAL MODE (4) - This mode is the default position that will start the machine. If the machine is started in any other mode, this switch must be reset to the MANUAL position. The rotor elevation control (2) is only active when the rotor mode control (1) is in the MANUAL position (4) .Note: Starting the machine with the rotor mode control at the TRAVEL position or the AUTO position will cause the display panel to indicate a fault code. No movement of the rotor will be allowed until the rotor mode control is reset to the MANUAL position.AUTO MODE (5) - This is the mode that is used for doing work. This mode allows automatic movement of the rotor. The movement is to a predetermined working depth.Note: The engine must be at high idle for proper operation of the Auto Mode.Use the following commands in order to maintain the working depth of the rotor when the machine is in auto mode:
Move the rotor mode control (1) to the MANUAL position (4) .
Move the rotor elevation control (2) in order to position the rotor at the desired working depth.
Move the rotor depth setpoint control (6) downward to the SET position and hold the switch until the display flashes depth. The value on the display panel (7) will be illuminated.
In order to maintain the set point, move the rotor mode control (1) to the AUTO position (5) .
When the machine is in auto mode, use the rotor elevation control (2) to make temporary adjustments to the height of the rotor. When the rotor elevation control (2) is released, the rotor will return to the set working depth.