SUPPORT ASSEM. 8N5584 - Caterpillar

Intended Use
This power module is intended for use in generating electrical power. The power module is a complete self-contained unit that can be towed to any location for the generation of electrical power. The power module can be utilized for prime power generation or standby power generation.Engine
Cat 3516C HD Engines provide the following features:
Four-cycle
Direct fuel injection
Mechanical Electronic Unit Injector (MEUI)
TurbochargedFuel System (Air/Fuel Ratio Control)
The fuel system includes these components:
Fuel metering valve
Engine control module (ECM)
Inlet Manifold Pressure Sensor
Load Signal
Inlet manifold temperature sensorThe fuel metering valve controls the flow of fuel to the engine. The ECM determines the requirement for the mixture of air and fuel. The ECM sends a signal to the fuel metering valve. The fuel metering valve controls the volume of the gas flow to the engine.The fuel flows through the fuel metering valve into the air inlet elbow. The mixture of air and fuel flows through the turbocharger compressor. The air/fuel mixture is cooled in the aftercooler. The mixture enters the manifold through a throttle which is electronically controlled.The ECM sends an electronic throttle signal to the electronic actuator. The throttle is controlled by the actuator.Lube Oil Makeup System
The lube oil makeup system is located to the right of the forward personnel access door on the right side of the power module. The lube oil makeup system consists of the following:
two sight glasses (1/3 full, and 2/3 full)
113.6 L (30 US gal) capacity
low-level sensor outputs to controller (used to give low-level warning alarm)Electronic Engine Features
Cat 3516C HD Engines are designed with electronic controls. The integral on board computer controls the operation of the engine. Current operating conditions are monitored. The Electronic Control Module (ECM) controls the response of the engine to these conditions and to the demands of the operator. These conditions and operator demands determine the precise control of fuel injection by the ECM. The electronic engine control system provides the following features:
Engine and auxiliary monitoring
Engine speed governing
Cold start strategy
Automatic air/fuel ratio control
Torque rise shaping
Automatic altitude compensation
Injection timing control
System diagnosticsFor more information on electronic engine features, refer to the Operation and Maintenance Manual, "Features and Controls" topic (Operation Section).Generator
The SR5 brushless generator can be used with the following loads: mixed loads of motors and lights, SCR-controlled equipment, computer centers, installations of communications and petroleum drilling applications.SR5 generators are utilized in three-phase full-wave excitation and regulation. The generator is a wye configuration intended for nominal voltages of 400V, and produces electrical power in 50 Hz applications.Power Module Enclosure
Basic Container
The enclosure for the power module is a shipping container. The container meets the following standards and regulations:
ISO/TC 104 Requirements for cargo containers
ANSI/ MH5.1 Basic requirements for cargo containers
ANSI/MH5.1.1 Requirements for closed van containers
UIC Code 592-1 International union of railwayLoad Cable Access Door
Illustration 1 g03642248
Load cable access door
Illustration 2 g03594125
Bus bar with connected load leads
The load cable access door is located on the side of the power module. The door has a lock handle that requires a Cat key to unlock, for access into the bus bar area.The load cable