SUPPORT AS 9U1716 - Caterpillar

Illustration 1 g01360864
Service - Calibrations - Choose the calibration procedure that is to be performedTo access the calibration procedures for the Machine Control ECM, establish the Cat ET connection to the Machine Control ECM. Navigate to the calibration procedures by clicking "Service", then "Calibrations". Click on the calibration that is to be performed.Once the specific calibration is selected, the Cat ET display will guide you through the calibration procedure.The Cat ET display will list the initial machine conditions that must be satisfied before the ECM will allow the calibration procedure to continue. Follow the specific instructions on the display in order to successfully complete the calibration procedure.If a calibration procedure is not completed successfully, exit the procedure and perform the procedure again. Verify that all of the listed machine conditions are correct and follow the instructions on the screen in order to complete the calibration successfully.During a calibration procedure, if the procedure must be aborted or the calibration is not successful, the ECM will use the previous calibrated values for control of the system.