SUSPENSION AS 6T1709 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5P-3931     Anti-Seize Compound     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01079977
Position precooler (5) and install bolts (4) .
Connect tube assembly (3) .
The alignment of the bellows is important. Improper alignment may lead to premature failure of the bellows. Misalignment can be identified by visually inspecting the convolutions for uniformity of compression.Inspect the bellows for damage prior to installation. If there is any damage to the convolutions, discard the bellows. Minor damage to the ends of the bellows may be repaired. However, if there is any difficulty in installation after the repair, discard the bellows.
The ends of the bellows are very sharp. Injury could occur if the bellows are not handled properly. Handle the bellows by the convolutions.
Install bellows (2). Apply Tooling (A) to the threads of clamp (1). Tighten the clamp to a torque of 12 2 N m (106 18 lb in).Note: Ensure that the bellows are not damaged.Note: Refer to Special Instruction, REHS1728, "Application Guideline for the Bellows" for additional information on handling the bellows.
Connect hose (7). Tighten the clamp to a torque of 7.3 0.5 N m (65 4 lb in).
Connect hose (8). Tighten the clamp to a torque of 7.3 0.5 N m (65 4 lb in).
Connect harness assembly (6) .
Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Refill Capacities" for the cooling system capacity.End By: Install the high pressure turbocharger. Refer to Disassembly and Assemb