SWASHPLATE AS 1767516 - Caterpillar

Illustration 1 g00270421
Illustration 2 g00270422
Torque SequenceRefer to Testing And Adjusting, "Flywheel And Flywheel Housing". This section will describe the correct method of flywheel housing inspection. (1) Put 5P-3413 Pipe Sealant on the four bolts.Tighten the bolts that hold the flywheel housing to the block in the sequence that follows.
Tighten bolts 1 through 8 in the numbered sequence to the following torque.Torque for bolts ... 135 14 N m (100 10 lb ft)
Tighten bolts 9 through 20 in the numbered sequence to the following torque.Torque for bolts ... 55 7 N m (41 5 lb ft)
Tighten bolts 1 through 8 in the numbered sequence again to the following torque.Torque for bolts ... 135 14 N m (100 10 lb ft)
Tighten bolts 9 through 20 in the numbered sequence again to the following torque.Torque for bolts ... 55 7 N m (41 5 lb ft)Note: After assembly, cut the gasket so that the gasket is flush with the bottom of the flywheel housing. (2) Put 5P-3413 Pipe Sealant on the stud threads. Install the studs until the studs extend from the housing by the following distance. ... 25.4 1.5 mm (1.00 0.06 inch)Flywheel Housing Runout
Face Runout (Axial Eccentricity) Of The Flywheel Housing
Illustration 3 g00285931
Typical example of an 8T-5096 Dial Indicator
Illustration 4 g00285932
Fasten a dial indicator to the crankshaft flange so the anvil of the dial indicator will touch the face of the flywheel housing.
Put a force on the crankshaft toward the rear before you read the dial indicator at each point.
The value on the dial indicator should be equal to 0.00 mm (0.00 inch) at location (A). Turn the crankshaft and read the dial indicator at location (B), location (C), and location (D) .
The difference between lower measurements and the higher measurements must not be more than 0.30 mm (0.012 inch). This value is the maximum permissible face runout. Face runout is also known as the axial eccentricity of the flywheel housing.Flywheel Housing Bore
Illustration 5 g00285931
Illustration 6 g00285932
Illustration 7 g00285936
Note: Be sure to indicate whether the measurement is positive or negative. This notation is necessary for performing the calculations in the chart correctly.
Fasten the dial indicator to the flywheel so the anvil of the dial indicator will touch the flywheel housing bore. Put the dial