SWASHPLATE 2000948 - Caterpillar

Illustration 38 g03332125
Attaching rear bolts to upper housing
Swing the upper housing backward and attach bolts to back of assembly.
Illustration 39 g03334136
Replacing side console front panel
Replace the side console front panel cover. Set in grove below lower panel assembly. Push the latches in place until snaps.
Illustration 40 g03332126
Assembled side console
Remove the protective film from face of 393-2300 Display Module Gp to complete installation procedure.Final Testing
Perform the following procedure for testing the assembled side console:
Illustration 41 g03332127
Side console testing
Perform base value display function check procedure. Refer to Table 2.
Table 2
Side Console Gauge and Light Test    
Step    Test    Operations Required    Actions required on machine prior to switching machine ON and starting test. Unless otherwise stated    Observed Results    Action Alarm Buzzer Active    
1     Power ON     Turn key switch start to the ON position     -     Cluster conducts self test     Yes during self test for short period    
Turn key switch start to the RUN position -     Engine starts     -    
Turn key switch back to ON position -     Engine should remain ON     -    
Turn key switch start to the OFF position (Please note for a number of tests, the engine will need to be running) -     Engine should stop, cluster switched OFF     -    
2     Tacho Gauge     Engine running     Rev engine to 1500 rpm (Dealer to verify engine speed against Tacho reading)     Needle points vertical     No    
3     Engine Coolant Temp Gauge     Engine running     Run the engine for 2 minutes and check the gauge has changed     Check needle has moved from left (indicating low temp)     -    
4     Fuel Gauge     Test can be carried out without engine running but key switch in ON position     Check that gauge is not reading zero     -     -    
- Remove connection to fuel sensor     Needle points to the left (indicating empty)     No    
- -     Amber LED lights up in position 19        
5     Torque Converter Temp Indication (On LCD)     Engine running     Switch the work lamps on>off four times within 8 seconds     Cluster backlighting should switch ON and OFF     No    
- -     LCD displays torque converter temp (If temp less than 30 deg c)     No    
6     Brake Level Warning Indicator     Engine running     Remove connection to brake level sensor on engine. SWG by connection pins 1 and 2 together     Red LED lights up in position 9     Yes    
- -     Action lamp will come on in position 11     -    
7     Engine Oil Pressure Low Lamp     Engine OFF, key switch in ON state     -     Red LED light ON in position 7     No    
Engine running -     Red LED light OFF in position 7     -    
8     Start Aid / Glow Plug Active Lamp     Engine running     Press